Where do I find the fault code on my XJ-S?
XJ-S will automatically display code 5 seconds after ignition is switched on. Fault code number should be seen on VCM or trip computer display. Fault codes can only be cleared by use of dealer JDS, PDU or similar (also to display fault codes) or by grounding the lead provided for the purpose from the ECU (see below).
How to read the Jaguar 3.6 fault code?
1. READING FAULT CODES JAGUAR 3.6 – LUCAS 9CU SYSTEM Code Display Procedure. When the facia display indicates “Fueling Failure” it is indicating that a fault has been detected. The fault identification number can be displayed as follows when the vehicle is stationary. Switch off engine. Wait 10 seconds.
Where do I find the fault code on my AJ6?
Fault code will now be displayed on facia panel (saloon) or trip computer (XJS). Attempting to start the engine will clear codes from memory. If the fault still exists it will be again registered. This provides a convenient way of checking when a fault has been rectified. Fault Identification Numbers:- Cranking signal failure. Airflow meter.
XJ-S will automatically display code 5 seconds after ignition is switched on. Fault code number should be seen on VCM or trip computer display. Fault codes can only be cleared by use of dealer JDS, PDU or similar (also to display fault codes) or by grounding the lead provided for the purpose from the ECU (see below).
1. READING FAULT CODES JAGUAR 3.6 – LUCAS 9CU SYSTEM Code Display Procedure. When the facia display indicates “Fueling Failure” it is indicating that a fault has been detected. The fault identification number can be displayed as follows when the vehicle is stationary. Switch off engine. Wait 10 seconds.
What are the fault codes for the AJ6 engine?
Fault codes and related functions are listed below. 15CU Fault Codes and Functions – 3.2 and 4 litre AJ6 Engine Idle pot. Looks for more than 4 volts on trim pot wire. Defaults to 2.5 volts. Air flow meter. Looks for air flow meter signal less than 0.2 or more than 4.5 volts between 400 and 300 r.p.m. Coolant thermistor.
Why does my Jaguar XJ6 engine not start?
For a period of approximately a month, the engine became harder and harder to start, until one day, it wouldnt start at all. The engine would crank and eventually start at time though.
What kind of transmission does a Jaguar XJ6 have?
Jaguar XJ6 Service and Repair Manual 3261 Jaguar XJ6 Models covered Jaguar XJ6 models with 3.2 litre (3239 cc), 3.6 litre (3590 cc) & 4.0 litre (3980 cc) six-cylinder in-line dohc petrol engines and automatic transmission
What to do if your Jaguar XJ6 won’t start?
If your XJ6 or XJ12 won’t start, grab your voltmeter and follow this checklist. Covers checking spark plugs, coil, wires and distributor cap, ballast resistor, amplifier and distributor pick-up, fuel supply, fuel pump and relay, air flow meter, fuel injectors and ECU.
Fault code will now be displayed on facia panel (saloon) or trip computer (XJS). Attempting to start the engine will clear codes from memory. If the fault still exists it will be again registered. This provides a convenient way of checking when a fault has been rectified. Fault Identification Numbers:- Cranking signal failure. Airflow meter.
How to troubleshoot the fuel pump on a Jaguar?
Remove the relay plug-in socket and determine which terminal cavity corresponds to the white/green wire. This wire goes right to the fuel pump. Using your jumper wire apply 12 volts to this wire for just a moment (you are bypassing the somewhat tricky control portion of this circuit).