Why does the parking brake not disengage on a 2005 Jaguar?

Re: parking brake will not disengage on 2005 jaguar s… Although a temporary workaround, disconnecting the battery and/or control module to release the park does not resolve why it became locked-on in the first place. The problem with many many S-types has been a failure of the park brake motor.

How to reset the ecu-1 Jaguar car forum?

Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to

What happens when you disconnect the battery on a Jaguar?

When the battery is disconnected, these adaptations are lost. On reconnection, therefore, some slightly abnormal drive symptoms may occur and the vehicle may need to be driven10 miles (16 kilometres) or more while the control system re-adapts. this is a simple link for resets after battery disconnect.

When to reset the clock on a Jaguar?

Refer to the audio systems handbook or touch-screen display handbook. • If the battery is disconnected for more than 72 hours the radio preset channels will need to be reset. • Reset the clock to the correct time.

How to calibrate the EPB on a Jaguar?

Still the same problem, locked in park and trying to calibrate the EPB mode but failing with the Cannot Engage Parking Break message. I tried the calibration method several times (pump the foot brake 5 times then hold down the foot brake lightly, apply the parking break, release the parking break and then the foot brake) which didn’t help.

Can a parking brake tip work on a JAG?

THIS TIP WILL ONLY WORK IFEVERYTHING ELSE like cables motor is in working order and the fault is causedby a electronic fault. http://s287.photobucket.com/albums/ll14 r%20forum/ I then had a look at my car and found that itwas different from what has been mentioned above (see photos.) I then replied to the above saying: – I have a 2005 XJ6 Jag.

Is there parking brake warning that brake cannot be?

Re: S type jaguar parking brake warning that brake cannot… “The vehicle was imobolised by a computer failure on 18th January 2010. On reporting my problem to your company, as the car was supplied by you and having done under 10,000 miles is under warranty, I was refered to the AA.

How to know if the parking brake is not calibrated?

4 Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE” is displayed on the instrument cluster message centre. This indicates the the parking brake is in calibration mode. 5 Lightly press the foot brake.

What to do if your parking brake won’t disengage?

To help avoid this problem happening again switch the ignition to position 2 (position just prior to starting) and press the chrome handbreak tab down while having your foot on the brake.The brakes will be released,the park brake light on the dash will go out and you can now start the car.

How to calibrate a jagrepair EPB motor?

To do this, set the system into ‘Calibration Mode’ by doing a battery reset. Then, with ignition ‘ON’ and the vehicle brakes at room temperature, lightly press the brake pedal and apply the parking brake. Date of issue 12/05 Bulletin Number XJ206-07 Page 3 of 10 DTC C1784 – EPB MOTOR OUTPUT SHORT TO GROUND.

What to do when the parking brake is released?

Warning:Ensure the vehicle cannot roll away when the parking brake is released. Chock the road wheels, and on automatic vehicles ensure the gear selector is in park. 4. Apply and release the parking brake five times using the apply/release switch. 5. Recheck the failure memory for DTCs. DTCs that return are permanent faults.

Do you need to uncouple secondary parking brake cables?

When replacing the EPB actuator, do NOT replace the secondary parking brake cables unless they are worn or damaged. The actuator primary cable should be uncoupled at the compensator. There is no need to uncouple the secondary cables. Unnecessary uncoupling can damage the cable retaining lugs. 3.

What does it mean if your parking brake is not on?

Keep it pushed down and take the ingnition keys out of the it will not start the parkbrake motor. Whe you next get in the car, you will not see the “Park” light come on meaning the parkbrake is not on. Only do this if the car is on the flat to be safe.

What to do if your parking brake is stuck?

Identical problems in the recent snow. Drove until first stop and then park brake locked on and Selector stuck in P. Jaguar Assist called and passed to AA. Selector sorted by lifting and moving lock located to left of gear stick. Brake still locked on.

How to change the parking lamp in a 2002 Jaguar S-type?

The AA disconnected the battery without sucess – but not for 10 minutes. Perhaps that would have solved it. The car had to be recovered to a dealer – its too clever for its own good! You can’t post conmments that contain an email address. How do you change the parking lamp in a 2002 jaguar s-type?

How do you change the parking brake on a Jaguar?

To recalibrate it disconnect your battery and leave for 10 Min’s. then reconnect and with the ignition on apply the foot brake and whilst keeping applied switch the parking brake on. then release the foot brake turn ignition off – on and the handbrake fault message should be gone and the parking brake should release as you drive off.

Is there a problem with the park brake on a JAG?

I have Jag xf 09 2.7 d luxury. When starting park brake fault comes up with the wording unable to use park brake. Took it to garage they have had a look and said a load of codes have come up and it will be a process of elimination which will probably become quite expensive. Any one else had this problem or know what to look for.

What causes hand brake problems in a Jaguar?

Also worth checking, and this can cause Hand Brake problems, is the state of the inside faces of the rear Discs, as these can wear/score quite badly, with this wear being concealed by the brake back plate assembly. Telfer.

Can a JAG XF 09 have a park brake fault?

Hi has anyone any ideas. I have Jag xf 09 2.7 d luxury. When starting park brake fault comes up with the wording unable to use park brake. Took it to garage they have had a look and said a load of codes have come up and it will be a process of elimination which will probably become quite expensive.

How to reset e brake module on Jaguar S-type?

Your problem may be due to low battery voltage, faulty park brake motor, module or possibly broken or binding parking brake cables. What you can do is reset the system. DIsconnect the negative battery cable for 10 minutes. Then reconnect it and start the engine. It will say “Apply park brake” on the messgae center.

Are there any problems with the jaguar’s type?

Seems to be a common fault on S type and apparently 05 was the worst year of manufacture for the amount of faults parkbrake issues being one I bought my car second hand and have had the intermitent parkbrake problem for more than a year …..

What happens when I manually release my parking brake?

This transition from manual to electronic means that if there is an electrical system failure, an electronic parking brake may become inoperable and not release. While this can make moving your vehicle difficult, Master Technician Bill McAleese of Garage Gurus shows you how to manually release…

What’s the park brake fault on a 2007 XJ?

I am new to this forum but am really frustrated with my 2007 XJ as it has let me down twice this week in the snow. The fault on rhe dash read Park Brake Fault and the brake warning light is lit. then when you sellect park it won’t let you out again and you have to get recovered.

How to release the park brake on a Jaguar?

I pulled the cover around the auto selector (remove ash tray and gently prize up with your fingers from the edge nearest the radio) and twisted the small plastic dowel 90 degrees (on the left side of the selector mounting). This released it from Park so I could get home.

What’s the emergency EPB release on a Jaguar?

Emergency EPB (Electronic Park Brake) Release? I’ve just had this problem after being parked up for 10 days (since before snow arrived). Fault indicated, could engage gear, tried to move in D and then in R, no luck. Called Jaguar Assistance, as I have extended warranty.

How do you get a Jaguar into Park?

To to get it into park lift out the cup holders, open little hatch underneath. Use the metal key insert to turn the lock/latch and lift the red fabric tape. It swings up and the N flashes. Don’t forget to release the handbrake too!

How do you put a Jaguar in neutral?

Press start button (no foot brake) to light up the ignition. Finger off button. Foot on brake. Put in neutral…? sorted now though, thanks! How did you manage to get it into neutral. It’s always good to know these things!

Can a parking brake be removed from a Jaguar?

Drove until first stop and then park brake locked on and Selector stuck in P. Jaguar Assist called and passed to AA. Selector sorted by lifting and moving lock located to left of gear stick. Brake still locked on. Battery removal no go. Removed the two plugs from Park Brake module (right hand side boot level with fuel filler.

What happens when the parking brake does not release?

Parking brakes can be mind boggling when it does not release. When the parking brake does not release, you can damage the transmission or engine trying to overcome the braking force. The parking brake system is simple in design and helps keep the vehicle from moving when placed at rest.

What happens when you release your brake on a hill?

When you release your brake on a hill without setting the parking brake, you will notice your car slide backward a little bit before it clunks to a stop. This is the parking gear rotating with your wheels until it comes solidly into contact with the pawl.

Navigation