Why does my light not work when I change the bulb?
If you have changed your light bulb and you have ruled out that it’s not a bad bulb, and the circuit breaker wasn’t tripped, the culprit might be the light socket not working. Here are some simple tips that you can follow to check the socket.
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
Why are the rear lights on my car not working?
The causes for dysfunctional rear lights are: 1 Burnt bulbs 2 Blown out fuse 3 Damaged wiring 4 Electrical issues
What should I do if my light fixture stops working?
Here are some simple tips that you can follow to check the socket. A continuity test is a basic test that you can perform when troubleshooting any light fixture, and it will help determine whether the electrical circuit is good or bad, continuous or broken.
Why does my trunk light not turn on?
The short story is that the trunk light is supplied +12v all the time through the red/white stripe wire. The Brown/white stripe wire is supposed to ground the trunk light through the switch on the trunk latch. The Brown/white stripe wire that went to the trunk switch was cut near the area where it runs by the drivers side hinge.
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
Where is the wire for the trunk light?
The Brown/white stripe wire is supposed to ground the trunk light through the switch on the trunk latch. The Brown/white stripe wire that went to the trunk switch was cut near the area where it runs by the drivers side hinge. The brown/white wire is now reconnected… and the trunk light works…
The causes for dysfunctional rear lights are: 1 Burnt bulbs 2 Blown out fuse 3 Damaged wiring 4 Electrical issues
If you have changed your light bulb and you have ruled out that it’s not a bad bulb, and the circuit breaker wasn’t tripped, the culprit might be the light socket not working. Here are some simple tips that you can follow to check the socket.
Why is my brake light not working after replacin?
If the bulb looks OK, you’ll want to test for power and ground at the bulb. Since the bulbs share more of the same circuit components, lack of power indicates a problem in the power side wiring. No ground would indicate a bad ground connection or a problem with the wiring on the ground side of the circuit.
What happens when you replace an incandescent light bulb?
The following scenario happens all too often: someone has a light fixture with an incandescent light bulb. After many months of service the bulb burns out. The bulb is replaced, but the fixture still is not working.
What should I do if my light bulb is loosening?
The constant on-off flow of electricity can sometimes loosen a light bulb in the socket. Simply screwing in tighter will fix the problem. Check the metal socket tab in the bottom center of the socket. If it has become flattened, you may have to bend it back up slightly in order for it to make contact with the bulb.