Where is my EGR located?
Hear this out loudPauseThe EGR valve is usually located near or attached to the intake manifold, with a tube running to the exhaust manifold. There should also be a vacuum or electrical connector (or both) running to the valve which will need to be detached.
Where is the EGR located on a diesel engine?
On most modern diesel engines, an EGR cooler is used to cool the temperature of the exhaust gas before it enters the engine. The PCM relies on the EGR temperature sensors to monitor the cooler’s operation. Generally, one temperature sensor is located on the exhaust manifold, and one is located near the EGR valve.
What to do if you can’t find the EGR valve?
Clean out the lines using a pipe cleaner if needed. If there are bolts attaching the valve to the engine, remove them. If the mounting gasket is in good shape you can set it aside and reuse it. Inspect and clean with carburetor cleaner and a toothbrush all the ports on the valve making sure the vacuum diaphragm moves freely.
Where is the EGR valve on a Dodge Avenger?
The 2009 Dodge Avenger EGR valve is not shaped like the old EGR valve; it is a cylinder shape on this vehicle. It is located on the left side of the engine near the front. Where is the E.G.R. valve located on a 2011 Mazda MX5?
Where is the EGR valve on a Hyundai Santa Fe?
Answer: You will find the EGR valve for the 2011 Hyundai Santa Fe by facing the engine, on the right side of the engine, look towards the back of the engine, very near the firewall. Question: Where is the EGR valve on a 2007 Silverado K1500 5.3 liter engine? Answer: On top of the engine just in front of the carburetor.
Where is the EGR valve on my car?
There should be a box or a can looking container attached off the side, right by that part of the air intake. It will be held on by 2 nuts, a couple computer plugs, and a vacuum line. That’s your EGR valve. Thanks! How do I reset the engine light after changing the EGR valve?
How do you replace an EGR gasket in a car?
Replace hoses if necessary. Remove the bolts holding the valve to the cylinder head. If you have trouble removing the bolts, spray them with WD-40 and let them sit before trying again. Remove the valve and any remaining gasket material. Avoid having debris fall into the cylinder head. Install the new EGR valve, following factory instructions.
How often to replace EGR?
You can clean an EGR valve, usually done every 15,000 miles, to prolong the life of the valve. It’s less expensive than a replacement, but the amount of work involved in cleaning an EGR valve is equivalent to a full replacement.
What should I do after cleaning my EGR valve?
If you have an electronic EGR valve, make sure to disconnect the negative battery cable, and remove any sensors and electrical connections before unbolting the valve. After cleaning, reinstall the valve and reattach the vacuum hose. To learn more, including how to tell when it’s time to replace your EGR valve, read on.