How to replace rear wiper motor Hyundai Tucson?

How to replace rear wiper motor Hyundai Tucson?

Remove the rear wiper cap and pad after removing a HEX nut….Wiper Motor

1. Remove the back door (hatch) trim panel.
2. Remove rear wiper arm, as follows: Remove the 2 claws. Remove the nut and rear wiper arm.
3. Remove rear wiper motor as follows: Detach the connector. Remove the 3 bolts and rear wiper motor assy.

How to remove Hyundai Tucson rear wiper?

1. Release the old blade. Lift the wiper arm off the window.
2. Remove the wiper. Once rotated, the wiper will release from the wiper arm with a gentle click.
3. Position the new blade. Place the small bar attachment on the new wiper blade into the hook on the wiper arm.
4. Lock the blade into place.
5. Done!

Where is the rear wiper switch on a Hyundai?

One thing I noticed is that when the switch is turned on a relay under the dash behind the driverside compartment, ticks. if you take that compartment thingy out it is right there close to driver’s door. Did you find the recommended reading relevant to this discussion?

When do I need to replace my rear wiper motor?

The rear wiper motor is used to turn the arm on your car’s rear window wipers. Since it is typically not used as often as the front windshield wiper, it receives a lot less wear and tear and is less likely to need replacing. However, when it does need replacing, it often gets neglected.

How do you remove the windshield wiper assembly?

To start removing the wiper assembly, the directions may change a little depending on your specific model of car. Normally, you should be able to pull the wiper arm away from the window so that it locks into place in a vertical or near vertical position. This will allow you to access the rest of the assembly so that you can remove it.

How do you remove battery from rear wiper motor?

Locate the car’s battery in the engine bar and find the negative terminal. The cable will be held in place by a clamp and a nut which holds the clamp in place. Remove the cable by loosening the nut. You should then be able to slide the battery cable off the negative terminal.