Do I need stabilizer links?
A worn-out sway bar link must be replaced to keep your vehicle safe. The answer is no, however your mechanic may recommend replacing both sway bar links because both links usually wear at the same rate and if one is bad, the other may go soon too.
When do you need to replace stabilizer bar links?
Both the bushings and the stabilizer bar links will eventually start to wear out with use, potentially causing your vehicle to lean excessively and become less stable on the road. When this happens, one or both of them will need to be replaced. It is strongly recommended that you replace left and right side links at the same time.
How do you remove a stabilizer link from a car?
Remove the left front wheel and tire, then take off the nuts and remove the stabilizer link on both sides. Steady the ball joint by placing a 6mm hexagon wrench on the stud. Take out the left and right side stabilizer link assembly.
What are the signs of a worn out stabilizer link?
Signs and symptoms of a worn out stabilizer bar link: 1 Clunking or knocking noise when going over bumps 2 Excessive body lean when going over bumps or during sharp turns 3 Noticeable play or looseness when moving the wheel 4 Poor vehicle handling or pulling to one side More …
What are the components of a stabilizer bar?
Stabilizer bar systems consist of several components including the stabilizer bar itself, stabilizer links, stabilizer link bushings or sockets, stabilizer bar to vehicle frame bushings, and bushing brackets to hold the bushings in place against the frame or unibody member.
How do you change the links on a stabilizer bar?
Start by spraying some WD40 on the existing nuts holding the links on the vehicle. Then, figure out which combination of tools you will need to use in order to remove those nuts. Step 5: Preparing to install the new end links. Once removed, go ahead and clean the area where the link ends bolt to the vehicle.
What do you use to tighten sway bar links?
Use a torque wrench to tighten the lug nuts to the manufacturer’s specification. With the vehicle at its normal ride height, use a torque wrench to tighten the sway bar link nuts to the manufacturer’s specification. Remember to hold the stud or bolt portion of the link while turning the nut.
How do you remove a stabilizer bar from a car?
Remove the Stabilizer Bar and Link. Loosen the lug nuts on the wheel slightly. Elevate the front of the vehicle. Make sure the supports are secure before proceeding. Remove the front wheel assembly. Remove the nut and the stabilizer bar link at each side of the vehicle. Take the rear mounting bolts off the sub-frame.
How do you replace a stabilizer link in a Toyota Corolla?
How to Replace a Stabilizer Link in a Toyota Corolla Raise the vehicle on a rack or on secure supports. Remove the left front wheel and tire, then take off the nuts and remove the stabilizer link on both sides. Steady the ball joint by placing a 6mm hexagon wrench on the stud. Take out the left and right side stabilizer link assembly.