How much does it cost to replace brake discs on Hyundai i40?
Save up to 30% on your Hyundai i40 brake discs & pads replacement. See our table above to browse our honest, upfront prices. What happens when we replace your front brake discs? Our efficient and fully qualified mechanics will establish which brake discs & pads need to be replaced and fit new ones as necessary.
How do you replace brake pads on an i30?
If one seizes up you’ll end up wearing your new pads/discs out prematurely. Squirt some penetrating oil on the set screws holding the front discs on, and use an impact driver with a good fitting bit to get them off, the metal is really soft and once the heads get chewed up you’ll have to drill them out to get the disc off.
How to put a brake pad on a Hyundai i40 Tourer?
Use a Torx 40 driver clockwise on the caliper motors female ” socket” until it stops turning. Then use a g clamp to press back the piston.. Reattach the motor drive unit using a bit of lubrication whilst there. Otherwise like any simpler non- EPB .
What is a tourer on a Hyundai i40?
Hyundai i40 Tourer – rear Brake Pad fitting – Robin the Technician. THE EPB are just electric motors that hold the pads against the disc when it is applied. When released the motors become free and can be safely rotated back without any damage.
How can I replace the discs on my Hyundai i40?
With the ignition on, plug a G-Scan into the 16P diagnostic socket and check for fault codes in the EPB and ABS systems. 2. With the vehicle raised, remove the rear wheels and check the condition of the brake hoses, parking brake motor cable and connections, and the rear brake pads and discs.
Can you change the brake pads on a Hyundai i40?
Please try again later. This video demonstrates the steps required to change the rear brake discs and pads of a Hyundai i40. Unlike most disc and pad changes this process requires input from suitable diagnostic equipment as the i40 has an Electric Parking Brake or EPB. Loading…
Hyundai i40 Tourer – rear Brake Pad fitting – Robin the Technician. THE EPB are just electric motors that hold the pads against the disc when it is applied. When released the motors become free and can be safely rotated back without any damage.
How big should rear brake pads and discs be?
2. With the vehicle raised, remove the rear wheels and check the condition of the brake hoses, parking brake motor cable and connections, and the rear brake pads and discs. The minimum disc thickness is 8.4mm and the minimum rear brake pad thickness is 2.0mm – as highlighted in AutoVista.