Can a bad ICM cause a crank sensor to go bad?
Therefore, the second symptom that leads you on the path of a BAD ICM or crank sensor is: No spark at any of the ignition coils. Of course, when it comes to Ignition System failures, this is not an absolute truth. These two components could display any number of behaviors when they go bad.
How does the crank sensor control the ignition module?
The ignition module starts to turn On and Off the ignition coils in their proper firing order to create spark, after the crank signal arrives. This On/Off action is the Switching signal referred to above. Under 400 RPM’s, the ignition control module controls spark timing without the help of the fuel injection computer.
What is the crank sensor on a GM 3.1L engine?
This article will help you test the ignition control module (ICM) and 3X crankshaft position sensor on all of the GM 3.1L and 3.4L overhead valve engines (the 3X crank sensor is also known as the 7X Crank Sensor).
Where is the CKP sensor on the ignition module?
As you can see, the CKP sensor signal is critical for the ECM and ignition control module to start sparking the Igntion coils at START UP and at all engine speeds. The CKP sensor is located on the block.
How does the ECM control the ignition module?
On most vehicles built within the last few decades, the sensor’s signal is sent first to the ECM. The ECM then uses this information to control ignition module operation. On some vehicles, the ECM may control ignition timing above a certain engine RPM, while the ignition module has control below a certain RPM.
Therefore, the second symptom that leads you on the path of a BAD ICM or crank sensor is: No spark at any of the ignition coils. Of course, when it comes to Ignition System failures, this is not an absolute truth. These two components could display any number of behaviors when they go bad.
The ignition module starts to turn On and Off the ignition coils in their proper firing order to create spark, after the crank signal arrives. This On/Off action is the Switching signal referred to above. Under 400 RPM’s, the ignition control module controls spark timing without the help of the fuel injection computer.
Can a crank and cam sensor be replaced?
I replaced both the cam and crank sensor and car still will not start but if I unplug the crank sensor it starts up and runs like crap. I can not figure out what to do next. My car has 91000 miles. My car has an automatic transmission. You should check to see if your vehicle has jumped timing.