How to draft a back and front skirt?
Connect 12B and 13B to 11B Fold 12B over 13B and connect 2 to 7B with a hip curve. 1-7F = ¼ waist + 1 ½ inches (4 cm). 4-8F = ¼ second hip + 5/8 inch (1.5 cm). 5-9F = ¼ second hip + 5/8 inch (1.5 cm).
What should I do if I set my rear brakes backwards?
Release the mechanical drive shaft brake, if any, put the vehicle in gear, and try to move off against the maxi brake. This is a quick check to ensure you haven’t set the rear brakes backwards. (See below.)
How do you tighten the brakes on a car?
Brake Adjustment is attained by adjustment of the Slack Ajuster by means of turning the adjusting bolt. The brakes are first tightened by rotating the screw in a direction which moves the tip of the slack adjuster – and the pushrod – TOWARDS the air chamber until it stops – at this position,…
Where do you park in front of a car?
Your indicator should remain on until you have completed the park. When in front of the vehicle you’re parking alongside, you should be about 1m away from it with the back of your vehicle in line with the front right corner of the parked vehicle (the right headlight).
Where can I find the sectioning procedure for my car?
Ask I-CAR receives many technical inquiries referring to sectioning. The collision repair industry wants to know where can you section, does the OEM have a sectioning procedure, and where can I find the sectioning procedure? Most OEMs allow sectioning to outer body panels and the front and rear rails.
Can You section the front of a car?
Most OEMs allow sectioning to outer body panels and the front and rear rails. Sectioning reinforcements is not as common, as most reinforcements are replaced at factory seams. Parts are made from various materials including HSS, UHSS, aluminum, and carbon fiber.
How do you set up front suspension blocks?
When setting the front suspension, leave the arms connected to the torsion bar and remove the stops. Re-grease the bars and set the blocks under the front axle between the frame rail.
Release the mechanical drive shaft brake, if any, put the vehicle in gear, and try to move off against the maxi brake. This is a quick check to ensure you haven’t set the rear brakes backwards. (See below.)