What are torque specs?
- Main and Rod Bearing Caps. Install the main bearing caps before installing the connecting rod caps.
- it is important to tighten all of the cylinder head bolts in small increments at a time until
- Exhaust and Intake Manifold Bolts.
- Other Components.
What are the torque specs for vehicles?
What Are the Torque Specs for Vehicles AMC Trucks GM Trucks. A lot of things go between the engine block and oil pan that help components to go round and round, up and down. 5-Liter, Inline Four-Cylider. The base engine offered in the 1999 Ford Ranger is a 2.5-liter, inline four-cylinder motor. 0-liter V6. 0-Liter V6.
What are the torque specs for the wheel bearings?
- seal contact surface and hub bore.
- (2) Install brake rotor shield to the knuckle.
- (3) Install hub bearing and axle shaft assembly or axle shaft into the housing and differential side gears. Avoid damaging the axle shaft oil seals in the axle housing.
What is the torque spec for the axle?
The front axle nut torque spec is considerably lower than the rear axle nut. The factory service manual lists the front axle torque spec as 70 to 75 foot pounds . We would always suggest reaching for the higher number on a larger fastener such as this. The front axle nut is metric. Use a twenty four millimeter socket with a reliable torque wrench.
Main and Rod Bearing Caps. Install the main bearing caps before installing the connecting rod caps.
- it is important to tighten all of the cylinder head bolts in small increments at a time until
- Exhaust and Intake Manifold Bolts.
- Other Components.
What is the head bolt torque specs?
Torque specs: Torque specs: CYLINDER HEAD BOLT TORQUE SPECS (tightening) / (loosening) 8, 4, 2, 6, 10 7, 3, 1, 5, 9. Torque in steps: 22ft-lbs (264in-lbs), Then to 63ft-lbs (756in-lbs) (final spec) 94+ Teg
What is head bolt torque spec?
Torque, as a specification for head bolts, refers to the amount of rotational force required to tighten the bolts properly . Torque is measured in foot-pounds. Manufacturers provide torque specifications to guide mechanics in properly tightening the bolts connecting the cylinder heads to the main engine.
What are the ARP bolt torque specifications?
Rod Bolts. Rod bolts with part no.
- and FBV8716 with 90 foot-pounds of torque using oil and 65 foot-pounds of torque using ARP lube.
- Cylinder Head Studs. Cylinder head studs with part no.
- Main Studs.