How to replace the windshield washer reservoir in a Hyundai Sonata?
Undo all the leads to your reservoir, including any hoses, guide wires and mounting bolts. After that, simply lift the windshield washer reservoir out of your Hyundai Sonata. With a pair of pliers, remove the washer pump from the reservoir. Throw away the seals–you’ll need to replace these when you install the new reservoir.
Do you need to replace seals on Hyundai Sonata?
Throw away the seals–you’ll need to replace these when you install the new reservoir. Reassemble your Hyundai Sonata by attaching the washer pump to the new windshield washer reservoir, replacing the seals and then putting the reservoir in your car by screwing it into place, replacing the mounting bolts and attaching the hoses and any other leads.
How do you reassemble a Hyundai Sonata?
Reassemble your Hyundai Sonata by attaching the washer pump to the new windshield washer reservoir, replacing the seals and then putting the reservoir in your car by screwing it into place, replacing the mounting bolts and attaching the hoses and any other leads. After that, reconnect the battery.
What to do if your windshield washer is not working?
If the fuse is good but the pump doesn’t run, disconnect the connector at the pump and check for power with a volt meter. With the washer switch on, it should read 12 volts. If you don’t hear the pump and the fuse is OK, the problem is usually a poor electrical connection at the pump or a bad pump.
What should I do if my windshield washer pump is not working?
Fill the pump’s reservoir to the necessary level with the solution. Use a funnel to help you. Use a formulated, non-freezing washer fluid in the wintertime. Unclog dirt from nozzles, hoses or screens. Use a long pin or fine wire to pick out or poke through clogged dirt. Follow by rinsing the parts that are exposed with water.
Why is my windshield washer not sending out fluid?
If your washer fluid is not being sent out when activated, the solution could simply be filling the washer system’s reservoir with more fluid or cleaning the nozzles and hoses. In more severe cases, the washer pump may need to be replaced. Here are steps to troubleshoot a windshield-washer pump. Check the washer fluid reservoir for dirt.
Why does my windshield washer pump make a humming sound?
Press the button and listen for a humming sound from the pump under your vehicle’s hood. If you don’t hear a sound, there’s either a problem with the fuse, your vehicle’s wiring, or the pump’s internal electronics. [1] Auto Repair & Design Specialist Expert Interview. 23 February 2021.
What to do if your windshield washer has ice in it?
In very cold weather, check for ice in washer fluid tank, you can try to use a warm hair dryer to defrost washer fluid pump and tank or spray windshield de-icer into washer fluid tank. If you are unsure if the pump is on, ask a friend to listen from outside the vehicle near the hood.