How to repair a Hyundai Sonata fuel filler door?

How to repair a Hyundai Sonata fuel filler door?

Repair procedures Hyundai Sonata YF 2011-2014 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator. Repair procedures 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing (A). Do not reuse the fuel filler door housing. 3.

What do you need to know about Hyundai Sonata YF?

Hyundai Sonata YF 2011-2014 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator. Repair procedures 1. Remove the trunk room left side trim.

Why did my Hyundai Santa Fe run out of gas?

Gas filler door stuck, almost ran out of fuel hyundai gas… I almost ran my tank dry the other day when I had to drive home with very little fuel because the gas filler door on my 2007 Hyundai Santa Fe doesn’t open when you pull the lever! It was pouring rain and I couldn’t get it open quickly so I decided to risk it.

Why is the fuel door on my Santa Fe not opening?

Very disappointed. What do I have to replace to get this to STOP? The fuel door on the Santa Fe has an electrical actuator to open the door and a back up release cable inside the vehicle near the door. The two main causes for the fuel door to not open are either a faulty electrical actuator or a worn door tension spring.

How to repair the fuel filler door release actuator?

Repair procedures 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing (A). Do not reuse the fuel filler door housing. 3. Remove the fuel filler door release actuator (A) after loosening the mounting bolts.

Repair procedures Hyundai Sonata YF 2011-2014 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator. Repair procedures 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing (A). Do not reuse the fuel filler door housing. 3.

Hyundai Sonata YF 2011-2014 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator. Repair procedures 1. Remove the trunk room left side trim.

Repair procedures 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing (A). Do not reuse the fuel filler door housing. 3. Remove the fuel filler door release actuator (A) after loosening the mounting bolts.

What happens when you replace the actuator on a blend door?

Once all of the mounting screws have been removed the actuator should become loose. Grasp the actuator and pull it from its mount to remove. Before installing the new actuator it’s a good idea to manually turn the blend door in both directions to ensure it is not stuck which will cause the new actuator to fail.

What do I need to replace car door actuator?

You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles. Using a small socket and ratchet remove the mounting bolts that hold the under dash plastic cover on the passenger side. These screws can be in obscure places so look around for them.

How much does a Hyundai Sonata door actuator replacement cost?

The average cost for a Hyundai Sonata HVAC blend door actuator replacement is between $209 and $226. Labor costs are estimated between $61 and $78 while parts are priced at $148.

How can I tell if my blend door actuator is bad?

To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level. Compare the bad actuator to the new unit.

How does the blend door actuator work in a car?

In a vehicle’s heating and cooling system, the blend door actuators help control the air temperature from the vents, and direct air to selected vents. How does the blend door actuator work? To blow heat into the cabin, the blower motor sends air through the heater core and on through the dash vents.

How to test blend door actuator, climate control, heater?

In some cases you can manually test the blend door actuator in others you can use computer for the diagnostics. There are usually a few blend door actuators that are part of the hvac system. This way you will know which blend door is bad and needs to be replaced. ► Like Us on FACEBOOK: https://www.facebook.com/worldmechani…

Posted In Q&A