What does the O2 sensor on a Tiburon do?
The oxygen sensors, also called “O2 sensors,” monitor the exhaust gases coming out of the engine. The sensors then send information to the Tiburon’s electronic control unit (ECU) which adjusts the air to fuel ratio to optimize fuel consumption and horsepower.
What does it mean when your oxygen sensor is running rich?
Basic Oxygen (O2) Sensor Codes If there is too much fuel and not enough air, the engine is said to be “running rich”, or “has a rich mixture”. It will have a gassy or rotten egg smell from the exhaust, give off a burning effect to the eyes and will make black smoke.
Why does the O2 sensor only read the exhaust?
Incorrect input from other sensors, such as the Mass Air Flow Sensor. The O2 sensors only read (O2) content in the exhaust. So, If you have all that unburned fuel from incomplete combustion then, you also have all that unburned (O2).
Where is the front jack on a Tiburon?
Use the floor jack to lift up on the front jack point located just behind the radiator on the Tiburon. The jack point is an extension of the frame of the vehicle and is the only safe jack point on the front of the vehicle. Place a jack stand under each of the front pinch welds on the driver and passenger sides of the Tiburon.
The oxygen sensors, also called “O2 sensors,” monitor the exhaust gases coming out of the engine. The sensors then send information to the Tiburon’s electronic control unit (ECU) which adjusts the air to fuel ratio to optimize fuel consumption and horsepower.
How do you repair an O2 sensor on a Hyundai?
Place the O2 sensor tool over the O2 sensor and turn it counterclockwise with a socket wrench to loosen and remove it. Thread and tighten the new O2 sensors using the O2 sensor tool and a socket wrench. Reconnect the electrical leads to the O2 sensors. “Hyundai Coupe, Sedan Repair Manual 1994-1998;” James R. Marotta, A.S.E.; 1997
Where are the Jack points on a Tiburon?
The jack point is an extension of the frame of the vehicle and is the only safe jack point on the front of the vehicle. Place a jack stand under each of the front pinch welds on the driver and passenger sides of the Tiburon. Lower the Tiburon onto the jack stands. Climb under the Tiburon and unplug the electrical leads from the O2 sensors.