Can a serpentine belt on a Hyundai overheat?
Since the belt turns the alternator, water pump and power steering in your car, failure of the belt can cause the engine to overheat, be hard to steer and allow the battery to discharge very rapidly. Inspect the belt often. Every time you change the oil you should check it. Locate the tensioner pulley on the front of your engine.
How do you put a stretch belt on a Hyundai i10?
Anyone can do a job quick. It’s doing it properly first time what counts. With stretch belts I usually jack the belt side of the car up place it in gear, cut the old belt off losely position the new belt on with it hanging off the bottom pulley and turn the wheel, in turn it turns the crank and the belt goes on.
How to change the serpentine belt on a Hyundai Santa Fe?
How to Replace the Serpentine Belt on a 2001 Hyundai Santa Fe. Open the hood of your Santa Fe and locate the negative battery cable at the battery. Loosen the retaining bolt that secures the cable end to the battery terminal using a wrench, and then remove the battery cable from the terminal.
What to do if your serpentine belt fails?
This could be due to a slippage or misalignment. The only way to make the noise go away is to contact a professional mechanic and have them replace the serpentine/drive belt or diagnose the issue. 2. Power steering and AC not working If the serpentine belt completely fails and breaks, then your car will break down.
What should I do if my serpentine belt starts slipping?
If a belt starts slipping, the tensioner should always be checked to see if it is functioning properly. With the belt off, visually inspect the tensioner for any cracks or signs of metal-to-metal contact between the tensioner arm and the spring case. Then spin the tensioner pulley manually.
Why is my serpentine belt cracking under the hood?
That awful squealing beneath the hood may be coming from a frayed or cracked serpentine belt. It’s a crucial part of the engine assembly—here are step-by-step instructions for replacing your serpentine belt without bringing your car to the shop.
How much does it cost to replace a serpentine belt?
The replacement cost is only going to be between $100 and $200 in most cases. The belt itself will cost between $25 and $80 while the labor costs will probably be between $75 and $120. Taxes and fees will be added onto these prices too. The ease of accessing the serpentine belt will determine how much the labor costs are.
Can a bad drive belt pulley cause wear?
If the drive belt tensioner pulley has any sort of issue it can cause unusual and accelerated wear on the belt. A bad pulley can cause fraying on the edges of the belt, and in severe cases can even cause it to break. 3. Belt-driven accessories fail Another symptom of bad or failing drive belt tensioner is failure of the belt driven accessories.