How do you get a stuck cassette out of a cassette deck?
You can do that with a long, slender flat-tip screwdriver, or anything of fairly similar shape. Hold down the eject button, and when the tape begins to rise, slide your prying tool underneath it and lift gently. Your tape should pop the rest of the way up so you can remove it.
How do you remove tape from a tape deck?
Insert a thin, flat-head screwdriver beneath the cassette tape inside the deck. Gently pry upward on the tape until it comes free from the tape deck’s heads. Grasp the tape with a pair of needle-nosed pliers. Pull the cassette out of the deck.
Why isn’t my tape player working?
Unplug the power cord or remove all the batteries from the player and let it sit for a minute. Note: If your device runs on batteries, make sure to use fresh or fully charged rechargeable batteries. Try to play the tape on a different player. If the tape still won’t play on a different player, the tape is faulty.
How do I eject a stuck tape from a library?
LTO Ultrium drives: First verify that there is no SCSI, SAS or FC bus activity to the library or drive, then reset the LTO drive through the Library Control Panel. Then, after the drive comes ready, press the unload button again to eject the tape. Power cycle the tape drive off the bus. Power down the tape drive.
How do you eject a tape from a hard drive?
When the unload button is pressed, the drive completes the current operation, rewinds the tape, unloads the tape from the tape path, and ejects the cartridge. Depending on the type of operation in progress and how close the tape is to the end, this may take several minutes. To check if there is an operation in progress, refer to drive’s LEDs.
How long does it take to eject a stuck tape?
This may take as long as 2 to 3 hours. Wait for the format recovery to complete and the tape drive to come ready, and then press the unload button again to eject the tape. Perform a manual tape extraction procedure. A manual tape extraction should only be performed in an emergency situation.
What should I do if my tape drive is stuck?
Power cycle the tape drive off the bus. Power down the tape drive. If the tape drive is installed in an autoloader or library, this means power-cycling the autoloader or library. Remove the firewire cable or SCSI cable and SCSI terminator. Wait 10 seconds, then turn the tape drive back on.
How to remove the radio in a 2006 Hyundai Tucson?
Loosen the bolt that secures the negative battery cable clamp to the negative battery terminal post, using a battery wrench. Remove the cable from the battery and secure it aside. Move to the Tucson’s interior.
LTO Ultrium drives: First verify that there is no SCSI, SAS or FC bus activity to the library or drive, then reset the LTO drive through the Library Control Panel. Then, after the drive comes ready, press the unload button again to eject the tape. Power cycle the tape drive off the bus. Power down the tape drive.
What causes a tape to not eject from the drive?
Some of the most common causes of the “tape will not eject” are listed below: A SCSI bus command Prevent Media Removal has been issued to the tape drive. A Prevent Media Removal command will cause the unload button to be ignored.
Power cycle the tape drive off the bus. Power down the tape drive. If the tape drive is installed in an autoloader or library, this means power-cycling the autoloader or library. Remove the firewire cable or SCSI cable and SCSI terminator. Wait 10 seconds, then turn the tape drive back on.