How do you remove the pulley bolt on a Hyundai?
I think its held on by upwards of 100 lb/ft of torque. alternatively, if the pully is on the passenger side, and the engine when running rotates clockwise (I think all Hyundai engines do – not sure about the Mitsu motors though) you can use a breaker bar pried against the ground and crank over the engine, that should break the bolt.
How much does it cost to replace a Hyundai wheel stud?
A extra lug you dont care about, or a nut that will screw completely down on the stud without hitting the wheels. New stud. its about 1.70 at hyundai parts. you may want to pick up another lug too, as one will get damaged (but is still perfectly useable) if you cant find a appropriate nut. a lug/stud pack is like 4 bucks i think.
What’s the best way to remove a crank pulley bolt?
If it’s a stick, placing the trans in 5th gear usually works. If your tires are off the ground, put it in 5th and have someone hold the brakes. This also works for tightening. BTW, use a torque wrench when tightening it.
I think its held on by upwards of 100 lb/ft of torque. alternatively, if the pully is on the passenger side, and the engine when running rotates clockwise (I think all Hyundai engines do – not sure about the Mitsu motors though) you can use a breaker bar pried against the ground and crank over the engine, that should break the bolt.
Is there a way to remove the crankshaft pulley?
Do not try to put in gear and remove the crankshaft pulley this will not work out well. The tool they are talking about can be made at home or purchased, and yes it will help. Basically it is a long bar with four holes to mount it to the pulley and a larger hole in the center to remove the nut.
How do you remove the pulley on a Land Rover?
I have the RAVE cd and have found the pulley section. It says to have someone hold a striaght edge something or other (perhaps a screwdriver) in somewhere to keep the crankshaft from turning when removing the pulley. I’m not understanding how this is done, maybe I’m just dumb or missing the point somewhere.
Which is the most stubborn crankshaft pulley bolt?
Crankshaft pulley bolt is the most stubborn, highly torqued and perhaps the most challenging bolt to remove in a car.
How to loosen a crankcase pulley on a Honda?
A simple way to hold the crankcase pulley so that you can loosen or tighten it. No expensive hard to find tools required, just a chain and breaker bar. A simple way to hold the crankcase pulley so that you can loosen or tighten it. No expensive hard to find tools required, just a chain and breaker bar. Skip navigation Sign in Search Loading…