Where is the seal on a Hyundai Accent door panel?
The door panel is hooked onto the top ledge where the window felt or seal is located. The curved edge at the top hooks to the horizontal ledge so while the bottom of the panel is tipped outward lift up to unhook and move the panel away from the door a few inches.
How to remove interior trim from Hyundai Accent?
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface Take care not to bend or scratch the trim and panels. 1. Remove the front door scuff trim. 2. Using a screwdriver or remover, remove the cowl side trim (A). 3. Installation is the reverse of removal. Replace any damaged clips.
What should I remove from my door panel?
Look behind the door panel and disconnect the electrical connectors from the window switch, door lock switch and the mirror as well. Remove the electrical connector that leads to the lower left marker light. Don Bowman has been writing for various websites and several online magazines since 2008.
How do you remove a trim fastener from a door?
Insert the common screwdriver between the door panel and the door at the upper most level of the rear of the door panel and slide it down until it contacts the first trim fastener. Carefully pry the fastener from its hole in the door. It is good to note that these door panels are nothing more than cardboard covered in material.
The door panel is hooked onto the top ledge where the window felt or seal is located. The curved edge at the top hooks to the horizontal ledge so while the bottom of the panel is tipped outward lift up to unhook and move the panel away from the door a few inches.
Look behind the door panel and disconnect the electrical connectors from the window switch, door lock switch and the mirror as well. Remove the electrical connector that leads to the lower left marker light. Don Bowman has been writing for various websites and several online magazines since 2008.
Insert the common screwdriver between the door panel and the door at the upper most level of the rear of the door panel and slide it down until it contacts the first trim fastener. Carefully pry the fastener from its hole in the door. It is good to note that these door panels are nothing more than cardboard covered in material.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface Take care not to bend or scratch the trim and panels. 1. Remove the front door scuff trim. 2. Using a screwdriver or remover, remove the cowl side trim (A). 3. Installation is the reverse of removal. Replace any damaged clips.