How does a camshaft actuator work on a Hyundai Sonata?

The Hyundai Sonata utilizes camshaft actuators to change the valve lift depending on the RPM of the motor. This allows for a more efficient cam profile at any speed. This increases both engine efficiency and power. Camshaft Position Actuators change the lift of the camshaft up to 25 degrees.

Is there an alarm on the Hundai Sonata?

Camshaft Position Actuator Circuit Cover… I have an alarm on 2015 Hundai SonataP001000 IntakeCamshaft Position Actuator Circuit Cover Plug, it is loose the dealer is replacing the plug and replacing an inner plug.

Where is the intake camshaft position actuator located?

Communication Number: TSB-15-01-022-1, Date: 2015-04-01 Category: 060000 ENGINE (PWS) Summary: HYUNDAI: DUE TO INCOMPLETE SEATING OF INTERNAL OIL SEAL PLUG AT INTAKE CAMSHAFT, CHECK ENGINE LIGHT WOULD ILLUMINATE WITH DIAGNOSTIC TROUBLE CODE (DTC) P0010, INTAKE CAMSHAFT POSITION ACTUATOR CIRCUIT. MODEL 2015 SONATA.

What are the symptoms of a Hyundai Sonata p0010?

Here are some of the typical symptoms of P0010 in the Hyundai Sonata: Poor Idle Quality – If the camshaft actuator fails while giving the engine aggressive valve timing, it’ll idle roughly.

What kind of VVT does the Hyundai Sonata have?

The list of VVT vehicles is growing, and the Hyundai Sonata can have VVT, and is prone to developing this code. P0010 is a generic OBDII code. This means that it has the same definition regardless of the make or model of the vehicle.

What is the trouble code on a Hyundai Sonata?

P0010 is a generic OBDII code. This means that it has the same definition regardless of the make or model of the vehicle. It has the same definition for the Hyundai Sonata as it does the Ford Taurus. If your Sonata has the P0010 trouble code it will typically not pass the State emissions tests.

Where are the camshaft sensors located on a Hyundai Sonata?

I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor. Was this answer helpful? elynbert will be eternally grateful.

How do you remove a camshaft position sensor?

You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2. Disconnect wire connector from sensor. 3. Remove sensor mounting bolts. 4. Remove the sensor from the rear of cylinder head. 1. Install camshaft position sensor in rear of cylinder head. 2.

Where is the intake CMP located on a Hyundai Sonata?

Intake cmp is on the front of the engine just below the valve cover almost even with the right side of the manifold. The exhaust cmp sensor is in the same location on the backside of the head. Was this answer helpful? I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor.

What kind of actuator does Hyundai Sonata use?

If your Sonata has the P0010 trouble code it will typically not pass the State emissions tests. The Hyundai Sonata utilizes camshaft actuators to change the valve lift depending on the RPM of the motor.

Navigation