Are there any recalls on Hyundai connecting rod bearings?
This time around, approximately 129,000 vehicles are under recall over bad connecting rod bearings. The story begins with a letter from June 2018 from the Center for Auto Safety, which petitioned the NHTSA to investigate a few non-collision-related fires.
Are there any recalls on the Hyundai Sonata?
Even though it’s getting better in terms of reliability, the Hyundai Motor Group is no stranger to engine problems. This time around, approximately 129,000 vehicles are under recall over bad connecting rod bearings.
Can a Hyundai engine be replaced with a new bearing?
Hyundai says the engine will be replaced with a new one if bearing damage is found by the service technician, which is a mammoth job in terms of labor. As an added level of protection, Hyundai will also enhance the engine control software with a Knock Sensor Detection System.
What kind of engine does a Hyundai Sonata have?
These include the 2012 Santa Fe, 2011 to 2013 and 2016 Sonata Hybrid, as well as the 2015 to 2016 Veloster. The engines in question are the 2.4-liter Theta II MPI, 2.0-liter Nu GDI, and the 1.6-liter Gamma GDI.
This time around, approximately 129,000 vehicles are under recall over bad connecting rod bearings. The story begins with a letter from June 2018 from the Center for Auto Safety, which petitioned the NHTSA to investigate a few non-collision-related fires.
Why is my Hyundai Sonata making a knocking noise?
The company says in documents that a worn connecting rod bearing will make a cyclical knocking noise, and it also could cause the oil pressure warning light to illuminate. Continued driving with the problem can cause the bearing to fail and engine stalling.
Even though it’s getting better in terms of reliability, the Hyundai Motor Group is no stranger to engine problems. This time around, approximately 129,000 vehicles are under recall over bad connecting rod bearings.
Where was the 2011 Hyundai Sonata engine made?
The company says that the 2011 Sonata was the first Hyundai vehicle to use engines made in Alabama, where the company initially used a mechanical process to remove machining debris from the crankshaft. That process was changed to a high pressure wet blasting system in April of 2012.
Why do I have a loose bearing on my crankshaft?
This is because a spun rod bearing, i.e., a loose bearing that rotates independently of the connecting rod and the crankshaft, seals the oil holes on the crankshaft. The result is less oil between the bearing and its cover, resulting in metal-on-metal contact.
When do you need to replace a rod bearing?
In the latter case, a connecting rod or bearings may be loosely installed, resulting in excess clearance, noise, and damage. When damage to a rod bearing is confirmed, it should be replaced.