What is OBD2 I m?
I/M readiness are self-checks that the OBD2 will run to ensure that the vehicle is operating efficiently and that the error code has been cleared. There are monitors that run each time the car is started while there are those that will only run under certain conditions of operation.
What is the drive cycle for a 2006 Hyundai Sonata?
Idle engine then idle in Drive for 1 to 2 minutes. Accelerate within 15 seconds to 50-55 mph (using 1/4 to 3/4 throttle) and keep this speed steady for 10 to 20 minutes.
How to do the drive cycle for a Hyundai Sonata?
2002 Hyundai Sonata V6 GLS Start your car from a cold start let it idle for 1 and 1/2 to 2 minutes. Then drive normal to the nearest freeway accelerate within 15 seconds pushing on the paddle at 1/4 to 3/4 , to a speed between 50-55. Do this for 2 and 1/2 to 3 minutes and then allow the vehicle to decelerate the zero without hitting the brake.
How is a sonata cycle different from a cyclic form?
In Music Theory. In the field of music theory, the term Sonata Cycle refers to the layout of a multi-movement work where the movements are recognizably in the forms of the tradition of classical music. It differs from the term cyclic form in that there is no unifying motive or theme used in all the movements.
Which is the first movement of a sonata?
The first movement is, by definition, written in sonata form, in a fast tempo (allegro), and in the home key of the overall piece. This movement can also be called the sonata-allegro.
How long does it take for an OBD drive cycle to start?
(Note: Drive cycle specifics vary by vehicle!) Ensure that the fuel tank is between 1/4 and 3/4 full. Start cold (below 86°F /30°C) and warm up until engine coolant temperature is at least 160° F (typically requires at least one minute; up to 3 minutes).
2002 Hyundai Sonata V6 GLS Start your car from a cold start let it idle for 1 and 1/2 to 2 minutes. Then drive normal to the nearest freeway accelerate within 15 seconds pushing on the paddle at 1/4 to 3/4 , to a speed between 50-55. Do this for 2 and 1/2 to 3 minutes and then allow the vehicle to decelerate the zero without hitting the brake.
How does a drive cycle work on a car?
A drive cycle is one of the methods used by a vehicle’s powertrain control module (PCM) to determine whether an emissions system repair was performed successfully. It involves a special test drive that duplicates the scenario of a person starting the car and making a short freeway trip, as if driving to work.
How to perform a basic drive cycle-repairpal?
The Drive Cycle and Emissions Readiness Monitors have, for the most part, stopped this unethical tactic. Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system.
What’s the first step in completing a drive cycle?
Step 1: Finish Repairs and Clear all Fault Codes. This is the step that many inexperienced mechanics tend to forget — but it’s the most important. After completing any emissions-related service, you need to clear all OBD-II diagnosis fault codes by using a professional digital scanner.