Can a speed sensor be replaced with a knock sensor?
It was pulling two codes the speed sensor on the transmission PO500 – and the knock sensor code was coming up along with that. I had the speed sensor replaced twice and checked the wiring.
What are the symptoms of a bad knock sensor?
Bad knock sensor symptoms 1 A failed knock sensor will register a trouble code and illuminate the Check Engine lamp (CEL), although some engines… 2 Misfire 3 Vibration, especially at highway speed 4 Thumping or knocking noise from the engine 5 Poor fuel economy and acceleration More …
What causes a shorted knock sensor on a Nissan?
But I can say that the scenario for a shorted knock sensor (a common failure on Nissan V-6 engines) to cause a fault code P0500 for a Vehicle Speed Sensor would involve a rodent eating wire insulation off of your engine harness causing some crossed wires. Or some other strange thing.
What does p0325 mean on a car knock sensor?
When the engine “knocks” there is an excessive amount of NOx that is released. When trouble code P0325 is set, this means that the knock sensor 1 in Bank 1 is not operating properly.
When does a knock sensor need to be replaced?
The P0324 knock sensor code, for example, usually appears when the knock sensor itself has gone bad and needs to be replaced. The P0325 knock sensor code, on the other hand, will often appear when your car is experiencing engine knocking.
What does the Check Engine light on a knock sensor mean?
If the computer doesn’t recognize a sound, it will illuminate the Check Engine Light. This is true for the knock sensor as well. If the knock sensor detects an abnormality, the computer will let you know with the Check Engine Light.
Is there a bad knock sensor on my computer?
Perhaps you could report the specific code. Note that NONE of these say “bad knock sensor” – the computer is clueless about the actual condition of the sensor itself. Its just a box of wires hooked by wires to other wires. That’s about it. I doubt your symptoms are from that though. You should troubleshoot the speed sensor code.
Where is the knock sensor on a Honda?
A car knock sensor is located on the intake manifold, cylinder, or engine block. The purpose of the knock sensor is to sense unusual pulsations caused by the engine detonation.
It was pulling two codes the speed sensor on the transmission PO500 – and the knock sensor code was coming up along with that. I had the speed sensor replaced twice and checked the wiring.
But I can say that the scenario for a shorted knock sensor (a common failure on Nissan V-6 engines) to cause a fault code P0500 for a Vehicle Speed Sensor would involve a rodent eating wire insulation off of your engine harness causing some crossed wires. Or some other strange thing.
Can a spark plug cause a knock sensor to go out?
Bad gas, worn spark plug and mechanical problems generally won’t result in a loss of signal from the knock sensors. This is a knock sensor problem, not a detonation problem. he was able to get a mirror or scope under the intake and observed some signs of rodent damage on the harness Rodents like closed-in cubbies like that.