Where is the third brake light bulb located?
For this reason it is important to replace the bulb in the high-mounted brake light when it burns out. Locate your car’s third brake light housing, which may be accessed from the rear package shelf below the rear window or from the upper-rear lining near the top of the rear window.
How do you remove a brake light from a car?
Use a flat-blade screwdriver to pry the housing up to release the holding clips if there are no visible screws on your housing. Pull the third brake-light housing slightly away from its mounting surface. Rotate the light bulb socket in a counterclockwise direction and pull it straight from the housing. Pull the bulb from the socket and discard it.
When to replace the bulb in a brake light?
Government studies indicated that vehicles that did not have a center brake light had a higher possibility of being involved in a rear-end collision. For this reason it is important to replace the bulb in the high-mounted brake light when it burns out.
How do you change the light bulb in a car?
Pull the lamp housing straight out from the rear of the cab. Twist the bulb socket at the rear of the housing in a counterclockwise direction and pull it straight out of the housing. Pull the bulb from the socket and insert a new bulb. Replace the lamp housing in the reverse order.
How do you replace the third brake light?
Find the third brake light package tray in the partition between the rear seat and the rear glass. Lift it upward to remove it. With the screws out, it comes up easily. Pull the bulb straight out of its socket. Insert the new bulb into the socket. Replace the third brake light package tray.
Do I need a 3rd brake light?
A third brake light, or center brake light, is not required under these laws. The conflict arises in court when an individual brings forth a case concerning a dispute arising from a stopped vehicle with a burned out, center brake light. Some judges believe that the law simply requires that motor vehicles have two brake lights.
How do you replace tail light bulb?
Step 1: Open the lift gate. Step 2: Remove the two 10mm bolts. Step 3: Pop the tail light free from the pins on the side. Step 4: Disconnect the tail light electrical connector. Step 5: Remove the light bulb fixture assembly. Step 6: Replace the bulbs. Step 7: Reinstall the bulb assembly into the tail light.
What is third brake light assembly?
The third brake light, as it is commonly called, is a brake light that sits high above a vehicle’s taillights. Designed to sit in the line of sight of drivers following a vehicle, the high brake light is intended to serve as a warning that a vehicle is slowing down.