What to do if your blower motor stops working?

Personally, I replaced mine when it stopped working and that solved the problem. There is a motor and relay below the motor that many folks replace at the same time, since both are known to fail. One form member even has an excellent write up about the replacement, including pics.

When do you need to replace the blower motor relay?

If the blower motor does not function, car fuses are blown, or relays are melting, you may have to replace the car blower motor relay. 1. Blower motor does not function 2. Blown fuses 3. Melted relay The blower motor relay is the electrical switch that is used to supply the power for the vehicle’s blower motor.

How long does it take to replace a Mercedes blower motor?

There is a motor and relay below the motor that many folks replace at the same time, since both are known to fail. One form member even has an excellent write up about the replacement, including pics. Very helpful! It’s about a 2-3 hour job, less if you’ve done one before. Thanks guys, I’ll look again. Must have missed it first time round

Why does my blower not come on in auto mode?

It doesn’t come on if in “auto” mode but if I put it in the “on” mode, the blower comes on and I have heat. I replaced the limit switch L170-40 and still have the same problem. There is another limit switch in the blower area L140-40. I checked this one with ohm tester and it seemed OK – it was closed tester beeped.

What should I do if my blower motor is not working?

The blower motor is crucial to the proper functioning of your HVAC system. This video will show you how to properly diagnose your blower by using the multimeter to perform an AMP draw as well as replacing the blower motor relay. Loading…

What are the symptoms of a failed blower motor resistor?

Blower motor resistor problems. Problems with a blower motor resistor are common in many cars. The most common symptom of a failed blower motor resistor is when the heater fan only runs at high speed and doesn’t work at low speeds.

How is the speed of the blower motor controlled?

The electronic module that controls the speed of the blower motor is called a blower motor control module. In some cars, the blower motor has only 4 or 5 fixed speeds. In this case, the speed of the blower motor is controlled by a blower motor resistor.

What happens when a blower motor relay wears out?

Without it, the AC system will not be able to circulate any heated or cooled air. The blower motor relay controls the current used to power the blower motor, and is subject to the constant on and off switching. Over time, it can eventually wear out.

Is the fuse on the blower motor okay?

The blower motor fuse is fine (the one on the driver side shock tower, right?). This blower motor problem has been discussed quite a few times, and you should be able to find solutions by searching these discussions. Look in the “stickies” at the top of the forum, DIY repairs. :nerd

Why does my Mercedes Benz blower stop working?

Im from Malaysia… i just want to ask why my blower stop working after i charge the gas in the system. like it suddenly stop. is it because its a burden to the blower? and..the compressor didnt stop eventhough i released all the gas. maybe there’s problem at the controller. but whats the reason this happen? sorry my english kinda suck. Hi.

What causes a bad or failing blower motor relay?

Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…

Why is my Mercedes Benz blower motor not working?

If there no power is found, the blower motor resister is the culprit and needs to be replaced. As a note, 85 percent of the time when the blower motor does not come on or operates at one speed only, the blower motor resister is at fault. The resister emits substantial heat from the resistance it supplies and eventually burns up.

What are the symptoms of a bad blower motor relay?

3. Melted relay. Another more serious symptom of a problem with the blower motor relay is a burned or melted relay. Relays are exposed to high current loads and can sometimes get hot when they develop problems.

What does it mean when a blower motor resistor fails?

In our case the ohmmeter shows open circuit, which means the resistor has failed. Sometimes, a blower motor resistor might fail due to problems with the blower motor itself. This means after replacing the blower motor resistor, check if the blower motor runs freely and doesn’t make any noise.

What to do if your Mercedes heater blower is not working?

My blower motor was fixed in with 3 posidrive screws. Had to use a stubby screwdriver on one of them too due to a serious lack of room. Check first before just pulling it out Rooty.

What causes a blower motor to stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Blower motors generally don’t fail out of the clear blue.

Why is my C230 Komp heater not working?

C230 Komp blower has been off and on since last year, and only working on 5 when it did. Worked fine over summer. Now that it is cold, it stopped for the most part. Read the threads here….pulled cover off from under passenger foot well and access the blower motor and wiring. Wiggled wires and checked connections and that did the trick.

How do you fix a blower motor on a car?

Disconnect the electrical connector at the blower motor and jumper power and ground to the motor, bypassing all the speeds controls. Run a fused jumper from the battery to the power side of the motor and connect a temporary grounding jumper to the other motor terminal.

Why is my AC blower not working on my 2006 Silverado?

2006 Silverado 2500HD blower speed control replacement. My brother has a 2006 Silverado 2500HD. The AC blower will not shut off. I know this is probably a bad resistor module under the dash so I ordered a new one. His has 3 wires in and two out to the blower motor. I was told there was an update kit and the new replacements have 7 wires in.

What to do if your blower fan stops working?

Take glove box out on passenger side. Upper left corner is Blower Fan Knock on it. If it comes on it is going out will need to replace. Blower fan will not come on at all? Check Fuses & Blower Fan? Fuses replaced for blower fan,took blower fan out and tested it and it worked? Well it has to be you climate control panel nothing else to check!

When do you Know It is time to replace your blower motor?

If you notice your blower motor is not functioning on certain speed settings, has a burning plastic smell, or the blower continues to run with the ignition in the off position, it may be time to replace your blower motor. Here are some steps you can take to confirm whether or not this replacement is necessary.

Why is my Mercedes air conditioner not working?

Your Mercedes vehicle will flash a host of service lights to inform you when something might be damaged inside the car. If the air conditioner unit is not running normally or is only blowing out warm air, it may be a temporary fault. Sometimes the unit isn’t actually damaged, and resetting your climate control unit

Is the heater blower on my car not working?

Heater Blower Not Working!!!! Hi guys, i’m sure this has been posted before but couldn’t find it when i just searched so sorry if it has!

Why is my air conditioning not working on my Mercedes S500?

What are common reasons my Mercedes-Benz S500 has air conditioning problems? While there are a variety of reasons your Mercedes-Benz S500 air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.

Where is the regulator on a Mercedes fan blower?

The Mercedes Benz fan blower motor regulator is a series of resisters in a printed circuit board about 2-inches square located right next to the blower motor.

Why is my a / C blower not blowing?

A metal that when it corrodes, it turns white, and unlike copper, aluminum corrosion does not conduct electricity at all and causes resistance issues and can cause overheating of a circuit. Took out a common finger nail Emory board and went to work, both sides of each contact, then used a small brass brush on each side and along the tips.

Where is the blower resistor on a 2017 Chevy?

Hit the A/C button, compressor is coming on, so not a low Freon issue. On the 2017, I located the blower resistor plugged into the duct on the passenger side, upper left area of the foot area, was surprised to find out that it could be accessed without even removing the cover for the blower area.

What causes a Nissan blower motor to run slower?

The auto AC regulates the fan control amp, which regulates the voltage to the blower motor. A low speed setting causes a lower voltage across the blower motor, which makes the motor operate slower. At maximum fan speed setting, the fan control amp allows nearly all 12v across the motor, which causes the fan to run faster.

Why is my blower not working on speed 5?

If your blower is not working on speed 5 then the blow motor resistor (I think its called that) is burnt and you need a new one. It is a 5 minute fix.

When does a blower motor need to be replaced?

CASE 2: The blower motor DID NOT run when you applied battery power and Ground with the jumper wires. This test result tells you that the blower motor is bad and needs to be replaced.

How does a 3 speed blower motor work?

Older style blower motor resistor with exposed resistor elements. The blower motor resistor is what’s responsible for giving you three blower speeds. The resistor block contains three different high resistance coils. Think of these coils like a filament in a light bulb.

Where do I replace the resistor on my blower motor?

To repair the problem, simply replace the resistor block. It’s usually located in the ductwork (to keep the coils cool) below the glove box. Unplug the electrical connector, remove the screws and replace the unit. Replacement blower motor resistor blocks are usually available from any auto parts store or the dealer.

Where is the number 1 on a blower motor?

Disconnect the blower motor from its two-wire electrical harness connector. Connect one end of the fused jumper wire to the blower motor male spade terminal labeled with the number 1 (in the illustration). This is the terminal that connects to the BRN/YEL wire of the connector.

Navigation