How to change the blinker light on a Dodge Ram?
This is a step by step instruction on how to change the sidemarker blinker bulb on your dodge vehicle. A 2003 RAM 2500 is shown, but other Chrysler vehicle may be similar. The light bulb called for is the 4157NA, also known as the 3157NA, the only difference is that the 4157 has a longer life. The NA denoted an orange colored lightbulb. Loading…
How do I replace the front turn light?
Locate the clips holding the inner fender liner in place and remove them. Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise.
Can you change the turn signal bulb on a Dodge Caliber?
When changing the turn signal bulb in your Caliber, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely. Advance Auto coupon for 20% off entire order: KIOSK20
How do you replace the engine light bulb?
Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise. Pull it out of the housing. Remove the old bulb. Install the new one. Check that the bulb is working.
Locate the clips holding the inner fender liner in place and remove them. Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise.
How to replace front turn signal bulbs on Dodge Ram?
Front turn signal replacement instructions offer the step-by-step guidance you need to switch out your old turn signal for a new one. This article applies to the Dodge Ram (2009-present).
How do you replace a turn signal bulb?
Turn signal bulb location. You might want to turn your wheel inward to give yourself more room. Once the flap is open, remove the safety clip from out of the lock position, and then turn the tab in a counter-clockwise direction, using force if needed. Remove the harness and bulb from the assembly. Remove the old bulb and snap in a replacement.
Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise. Pull it out of the housing. Remove the old bulb. Install the new one. Check that the bulb is working.