Where do you connect a test fuse to?
View our large range of fuses. Connecting the Test Leads. The black lead should be connected to the Common socket. The red lead should be connected to the Ω or Ohms socket. Not sure what fuse you need?
How can I tell if my Fuse has been blown?
Test the fuse. Listen for the multimeter to beep continuously as you hold the probes against the fuse. If you don’t hear any noise coming from the meter, then the fuse is blown and should be replaced. If you’re using a digital multimeter set to measure resistance, touch the probes together to get an initial reading.
Where are the fuses for the dashboard lights?
Check under the hood, under the dashboard, or near or in the glove compartment. Once you find the fuse box or boxes, remove the lid and check the diagram on the underside of the lid for a fuse labeled “dash lights” or just “lights.” Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse.
How do you test for a bad fuse on an RV?
However, you can test for a bad fuse to verify that is the problem. Place a 12-volt meter at the bare metal section on the top of the fuse. If it is not lighting up, it is a bad fuse. Newer RV distribution panel models will have lights underneath the fuses and if the light is on, it is indicating the fuse has gone bad.
Where does the test light go on a fuse?
The fuse is just in line downstream from the battery and then switch to power it up. Now using an ohm meter is different. You would get a reading regardless of the circuit being powered up. IF the circuit is powered, you should get a light ON on both sides of the fuse. If it’s not powered, it should be OFF both sides.
Where is the fuse panel on 1989flhtcu?
Found them they were covered in dust after removing the dust from the top I could see the map to the fuses. It’s not on the left side unless you have to take apart one of the 2 boxes located on the left side. Where is the fuse panel on 1989FLHTCU ?
How can I tell if my fuses are constant or switched?
Since the engine is off and the key is out of the ignition, you should be able to probe the fuses and determine which are constant. The constant fuses are the fuses that light up your circuit tester. If you find a combination of both constant and switched fuses in your fuse box – great!
What should I do if my Fuse is still working?
If the fuses are all still working, there is likely a more serious problem and it may be time to call on an expert. Turn the equipment off and remove the fuse. Make sure the device, equipment, or vehicle is turned off before the fuse is removed. To remove the fuse, simply pull it straight out of the slot.