How much torque do you put on a General Motors car?
Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 37 ft-lbs (50 N-M). Upon initial installation of replacement ball joint, tighten nut to to 81 ft-lbs (110 N-m). 2. Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 48 ft-lbs (65 N-m). 3.
What are the different types of torque converter bolts?
6.78 3800 II – Torque Converter Cover Bolts Type: Bolt 74 888 100.33 3800 II – A/C Compressor Mounting Bolts – FRONT NUTS Type: 59 708 79.99 3800 II – A/C Compressor Mounting Bolts – LOWER BOLT Type: Bolt 23 276 31.18 3800 II – A/C Compressor Mounting Bolts – REAR BRACKET Type: Bolt 36 432 48.81 3800 II – A/C Compressor Mounting Bolts – UPPER BOLT
How big of a torque nut do I Need?
Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 37 ft-lbs (50 N-M). Upon initial installation of replacement ball joint, tighten nut to to 81 ft-lbs (110 N-m). 2. Tighten to 8 ft-lbs (10 N-m), then tighten an additional 1/3 turn to at least 48 ft-lbs (65 N-m). 3.
What are the torque specifications for a 3800 engine?
3800 II – EGR Valve to Intake Manifold Adapter Type: 37 444 50.17 Type: 55 660 74.57 3800 II – Engine to Transaxle Bolts Type: Bolt 50 600 67.79 3800 II – FRONT Engine Mount to Frame Nuts Type:
Why is my C3500 dually spindle torque so low?
Damage can result by the steady pressure on the roller ends which come from preloading. – Tighten nut to 12 ft lbs while turning the wheel forward by hand. This will seat the bearing. – Adjust nut to a “just loose” position by hand, then back the nut off until the hole in the spindle aligns with the slot in the nut.
What happens if your spindle nut is over torque?
It will also leave your spindle nut under or over torque resulting in hub assembly failure. Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life.
Can a calibrated torque wrench install an axle?
Use a qualified, calibrated torque wrench. Do not use an impact gun to install the axle nut. The impact gun will damage the axle nut. It will also leave your spindle nut under or over torque resulting in hub assembly failure.
What are the torque specifications for a General Motors truck?
TORQUE SPECIFICATIONS GENERAL MOTORS APPLICATION FT-LBS / ( N-m) AXLE SHAFT FLANGE BOLT ‘S’ BODY CAR 27 (37) TRUCKS 60 (82) AXLE SPINDLE NUT ‘A’ BODY 192 (261) ‘C’ ‘E’ ‘H’ & ‘K’ BODIES 180 (245) ‘J’ & ‘L’ BODIES 191 (260) ‘P’ BODY 200 (271) ‘S’ BODY CAR 137 (186) ‘T’ SERIES TRUCK