Why does my Santa Fe engine not start?
There are a lot of issues that can cause your Santa Fe to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes.
How to know if your engine has no spark?
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
Why does my car not start when I crank the engine?
The crankshaft position (CKP) sensor monitors the position or rotational speed of the crankshaft. If the crankshaft position sensor has failed completely, and isn’t sending a signal to the (ECU) at all, then the computer won’t send any fuel to the injectors. This will leave you unable to start the car.
Why does my car not start with starting fluid?
If you have proper fuel pressure, spark, and the injectors are working, it does not have a choice but to run. However, since it will not even start with starting fluid indicates a few possibilities. One of the following has to be wrong: weak spark, engine timing, or low engine compression.
There are a lot of issues that can cause your Santa Fe to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes.
What does it mean when a Hyundai won’t start?
Will crank over but won’t fire up. Hyundai won’t start. Will crank over but won’t fire up. Car suddenly died and won’t start again. Heard a pop under Car suddenly died and won’t start again. Heard a pop under the hood … read more It wont start intermittently. Sometimes it starts and runs It wont start intermittently.
What kind of car won’t start up?
I have a 1997 Hyundai Lantra that will not start.The engine cranks over well but will not fire. I have fuel pressure at the filter and I even clamped … read more
What happens when there is no spark in the engine?
When there is no spark, the engine will not start. You’ll probably have a misfire related code such as P0300, P0301, etc….. Ignition issues can be caused by many things, including bad spark plugs, bad coil packs, bad plug wires, computer issues, and more.
When does the new Hyundai Santa Fe come out?
New 2020 santafe took delivery on January 4th, 2021, with less than 5000 miles on March 21st the vehicle refuse to start after it was started and shut off while we were sitting in a parking lot. While attempting to start it getting forward collusion warning but the engine would not crank.
Is there any way to fix a Hyundai Santa Fe?
Total electrical failure with no recourse at the moment, Hyundai motor of America consumer affairs wants us to sign a settlement agreement to refund our expenses and have not fixed or replaced the car.
What to do if your Hyundai Santa Fe wont start?
If you do not hear the pump at all check ECU B+ 15 Amp fuse (hot at all times) and the fuel pump relay, if good suspect that you have a defective fuel pump. Make sure spark plug wires are plugged correctly. Good luck. 19 people found this helpful. Alfonso…. you seem to know a lot about cars. I need help with my 2004 Hyundai Santa Fe. Please!!
When does a Santa Fe starter go bad?
When a starter goes bad, they will usually not give you much warning first. Also, if you are stuck somewhere and are trying to start your Santa Fe, the old beat the starter with a hammer trick is not a wives tale. It really can get that one last start out of it. There are a lot of issues that can cause your Santa Fe to crank, but not start.
What to do about Hyundai 2.4 engine problems?
The solution for many of the vehicles was a costly engine block replacement. Hyundai and KIA car owners with the 2.4 engine cited various problems including the timing chain. Check out what some owners had to say!
If you have proper fuel pressure, spark, and the injectors are working, it does not have a choice but to run. However, since it will not even start with starting fluid indicates a few possibilities. One of the following has to be wrong: weak spark, engine timing, or low engine compression.
When did my Hyundai Santa Fe start having issues?
I am also elderly and need a car that runs. My 2008 Hyundai Santa fe started having issues in Jan 2017. “No Start No Crank”. It would happen once a month or so and now it seems like it is once a day or every other day. I have 135,000 miles on it.
Can a Hyundai Santa Fe stall while driving?
“Accounts posted on the Internet by Class Vehicle owners over a period of several years vividly illustrate the extreme danger posed by the Stalling Defect,” the complaint states. The plaintiffs claim Hyundai says it believes the vehicles can stall when the driver is braking at low speed, which can momentarily reduce the engine RPM.
When do you need a new starter for a Hyundai Santa Fe?
If the click happens and the solenoid and/or starter do not engage, you probably need a new starter. Once the starter is removed, an auto parts store can bench test it for you before selling you a replacement. If the click does not happen, the starter relay, ignition switch, or wiring may have a problem.
Why does my Santa Fe engine shut off without warning?
Apparently, this is common with 2013 model Hyundai Santa Fe sport engines after discussing it with their customer service representative.
Why does my 2017 Hyundai Santa Fe not start?
See all problems of the 2017 Hyundai Santa Fe . Navigation screen does not turn off after the ignition is turned causing the battery to drain and car will not start. My new 2019 Hyundai sante fe from the time I bought it had the yellow check engine light come on. It said the bsm system wasn’t working.
Why does my Hyundai Santa Fe stall in traffic?
The Hyundai Santa Fe drives and handles well, overall, but I had three terrifying incidents on the first day driving the car to work in rush hour traffic. The Hyundai just stalled, always when moving to a red light and/or in stop and go traffic. Seems consistent with engaging the brake pedal to slow down or stop.
Where can I get a Hyundai Santa Fe engine replaced?
The contact stated that while driving about 40 mph, the vehicle shut off. Without warning. The vehicle was towed to the hanlees hilltop Hyundai dealer (510-222-8882, located at 3285 auto plaza, richmond, CA 94806) where it was diagnosed that the engine needed to be replaced.
What is the failure code on a Hyundai?
As an example, one flash, followed by a 2 second pause, followed by two flashes and another 2 second pause, followed by two flashes and a 2 second pause, followed by three flashes and another 2 second pause, indicates a failure code 1223.
What are the codes for the Hyundai Elantra?
If codes reappear, substitute a known good ECM, and recheck codes. Hyundai Stellar vehicles. Hyundai Sonata, Excel (90 on), Scoupe (91 & 92), Elantra. Hyundai Scoupe (93 through 95) and Accent vehicles.
What are the computer codes for Hyundai Sonata?
COMPUTER CODES for Hyundai Vehicles. CODE Hyundai Sonata, Excel (90 on), Scoupe (9 1 Electronic Control Unit (ECU) (one long 2 ECU system normal 11 Oxygen sensor or circuit 12 Airflow sensor or circuit
What kind of starter does a Hyundai Santa Fe use?
Hyundai Santa Fe Questions – The starter won’t even crank the engine. – CarGurus The starter won’t even crank the engine. I bought a new batt but that is not it.
What’s the problem with my 2013 Santa Fe?
No one has added a helpful site for this 2013 Santa Fe problem yet. Be the first! Read reviews of repair shops in your area. Enter your zip code: This is the same intermittent starting problem that others have complained about for years. Car will not start about every 8 tries. Lights come on, radio, everything but no starter engages.
Why is my Santa Fe ignition not working?
04 Hyundai santa fe 2.4 Po320 ignition fail sensor code in pcm and tach not working. car runs fine and its not the crank sensor. changed the ign fail sensor and that did not fix it, The wireing diagram shows a ground, a power, a ignition control signal to ecm and a wire from the coils. All wires tested good. Can anyone help with possible causes??
What causes a Hyundai Santa Fe to stall?
The crankshaft position sensor may fail, causing engine stalling or a failure to start. Replacement or the failed sensor will commonly correct this problem. The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111.
Hyundai Santa Fe Questions – The starter won’t even crank the engine. – CarGurus The starter won’t even crank the engine. I bought a new batt but that is not it.
What kind of engine does the Hyundai Santa Fe have?
The crankshaft position sensor failure affected quite a few engines in the Santa Fe lineup, including Hyundai’s 2.0-liter four-cylinder, 2.4-liter four-cylinder turbo, 2.7-liter V6, 3.3-liter V6, and 3.5-liter V6 engines. The problem occurred at an average mileage of 103,710 miles.
I am also elderly and need a car that runs. My 2008 Hyundai Santa fe started having issues in Jan 2017. “No Start No Crank”. It would happen once a month or so and now it seems like it is once a day or every other day. I have 135,000 miles on it.
If the click happens and the solenoid and/or starter do not engage, you probably need a new starter. Once the starter is removed, an auto parts store can bench test it for you before selling you a replacement. If the click does not happen, the starter relay, ignition switch, or wiring may have a problem.
Is there a gas leak in my Hyundai Santa Fe?
Took my car to a two mechanics who both said there is a gas leak in the evaporator of the emission control system. I read online that this issue is common with Santa fes and I believe the company should issue a recall and get this dangerous issue fixed. The contact owns a 2008 Hyundai Santa Fe.
Engine Won’t Start – If your Santa Fe’s timing chain or belt has fallen off completely, broken, or has jumped a few teeth, it is entirely possible that the engine won’t even start. You might hear it slapping around as the engine cranks over.
What does it cost to have a SANTA FE engine hesitate?
received a Engine hesitates during acceleration Inspection. Hyundai Santa Fe Engine hesitates during acceleration Inspection costs $85 on average. It can be frustrating for any driver to expect certain acceleration from their vehicle only to find that the vehicle seems to be hesitant while speeding up.
Why does my Santa Fe y2006 not start?
Hello, my Santa Fe Y2006 has this same problem. New glow plugs, currently changed crankshaft position sensor, battery in good condition, starter spins perfectly but no starting when cold (in the morning). Possible to start only after spraying of starting fluid directly to air filter outlet. Once started it will run all day with no problems.
Why does my Hyundai Santa Fe have no crank?
Loose or corroded major electrical connections such as grounds or especially battery clamps are also common causes of no-cranks. Finally, a battery on its way out can cause this symptom. I went to car dealer last night.
Is the Santa Fe a front wheel drive car?
Based on the company’s front-wheel-drive Sonata sedan’s platform, the Santa Fe again is offered in GLS trim. A new Limited trim level has replaced the LX for 2006.
What was the problem with my Hyundai Santa Fe?
Search CarComplaints.com for these popular complaint phrases… My 2008 Hyundai Santa Fe stalled twice today. It also stalled on the same day twice last week. This happened each time I came to a stop light or wanted to make a turn. The engine stopped running, the power steering ceased working, and check engine light came on.
As of 2019, the Santa Fe has been slotted between the Tucson and the Palisade . In its first year in production, the Santa Fe was offered with one of two engine and transmission combinations. In North America, a fuel-efficient 2.4 L four-cylinder engine was standard equipment and could be mated with either a 5-speed manual or a 4-speed automatic.
When did the third generation Santa Fe come out?
In 2012, the third generation Santa Fe became available in two versions (regular and extended versions), with the (five-seater) Sport in September 2012 and the extended long wheel base model which replaced the Veracruz, available at showrooms in November 2012.
Are there any problems with the Hyundai Santa Fe?
The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Hyundai Santa Fe based on all problems reported for the Santa Fe.
How big was the fire in the Hyundai Santa Fe?
By the time the fire department arrived, the vehicle was totally engulfed in flames, which reached almost 10 feet high. The fire fighters were able to contain the fire before it reached the fuel tank, but the vehicle and its contents were totally burned. The vehicle was a shell of metal and ash when it was towed away.
When there is no spark, the engine will not start. You’ll probably have a misfire related code such as P0300, P0301, etc….. Ignition issues can be caused by many things, including bad spark plugs, bad coil packs, bad plug wires, computer issues, and more.
What happens if your Hyundai Santa Fe fuel pump goes bad?
If your Hyundai Santa Fe’s fuel pump goes bad, no fuel (or not enough fuel depending on whether or not it’s out all the way) can enter the engine. Without gas your Santa Fe will not run at all. With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all.
What do you need to start a Hyundai Santa Fe?
At the most basic of levels your Hyundai Santa Fe needs three things to start: Air, fuel, and spark . If any of these things aren’t present, the engine won’t turn over at all.
What are the symptoms of a bad fuel pump?
Also, the symptoms are almost exactly the same as bad/clogged fuel filter. Here are the most common symptoms of a bad fuel pump in your Hyundai Santa Fe: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues.
Why does my car have no fuel injector pulse?
I bet if you connected a test light to a fuel injector wiring connector while trying to start, you would find that you have no fuel injector pulse either. This is because the crankshaft position sensor gives the signal for both fuel and spark, and it is very common for this sensor to fail on this vehicle.