Is it better to do a transmission rebuild or replace?
A transmission rebuild is a great option in most cases. This means you are only replacing the parts that have failed. Just like a replace, you are fixing certain parts, but not doing it in a factory setting. You will want a very reputable repair shop to have this done.
Which is the most expensive option to replace a transmission?
Atransmission replacementis the most expensive option when fixing your transmission. In many cases, you will hear this referred to as “re-manufactured.” Basically, the manufacturer will replace parts that have gone bad with modified parts. This is an option if the transmission is too damaged to even consider a rebuild.
What happens when a transmission speed sensor goes bad?
If your car is equipped with cruise control, this functionality is usually one of the first things to suffer when a transmission speed sensor malfunctions. Without a properly functioning sensor, the ECU isn’t receiving information about the car’s speed. This makes it impossible for the vehicle to maintain a constant velocity.
Which is the first option for a transmission repair?
The first option for fixing a transmission is to have it “repaired.” Having the option to do a repair is less likely because it can’t be done if the parts that are going bad have caused too much damage.
How do I get the VSS out of my car?
Apply the parking brake, block the rear wheels, then raise and safely support the front of the vehicle on jack stands. From under the right-hand side of the vehicle, disengage the wiring harness connector from the VSS. Loosen the VSS hold-down bolt, then pull the VSS out of the transmission housing.
What should resistance be for VSS speed sensor?
Disengage the wiring harness connector from the VSS. Using a Digital Volt-Ohmmeter (DVOM), measure the resistance (ohmmeter function) between the sensor terminals. If the resistance is 190–250 ohms, the sensor is okay. Vehicle Speed Sensor Replacement REMOVAL & INSTALLATION(older models)
How is the VSS sensor used in the PCM?
OPERATION The Vehicle Speed (VSS) Sensor input is used by the PCM to determine vehicle speed. The VSS generates a signal that increases in frequency proportionate to vehicle speed. The PCM has a base frequency stored in memory for a distance of one mile.
When do you know you have a transmission problem?
You may be experiencing a problem with your transmission if your vehicle is exhibiting any of the following symptoms below: