How do you reset a washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
How do I reset my top load washer?
Motor Reset Procedure:
- Unplug the washer for 1 minute from the electrical outlet.
- Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
- The motor has now been reset and is ready for you to start a cycle.
Why does my Whirlpool washer stop mid cycle?
Whirlpool Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Why is my Whirlpool washer not working?
Filling Without Spinning or Rinsing. If your washer fills properly but neither spins nor rinses, the most likely problem is with the drive belt, accessed via the back panel of the washer. If the belt is broken or has slipped off, the motor to activate spinning, rinsing and agitating will not function properly.
How do you reset a whirlpool front load washer?
How To Reset Whirlpool Cabrio Washer: Turn the washer off. Set the mode selector dial to NORMAL. Turn the dial counter clockwise ONE click (LEFT), clockwise THREE clicks (RIGHT), counter clockwise ONE click (LEFT) then clockwise ONE click (RIGHT).
Why is my Whirlpool duet washer not draining?
When a washer won’t drain, it’s usually because there’s a clog or the pump is broken. If you figure out what’s causing the issue, you may be able to fix it yourself. To find out what’s preventing your washer from draining, you’ll need to access the parts of your machine to check for damage or clogs.
How do you clean a whirlpool duet washing machine?
Open the door of the Whirlpool Duet washer and look for stains on the gray seal located just inside the machine. Gently pull the seal back to look for stains underneath as well. Apply the diluted bleach solution to a clean rag and wipe away any stains. You can leave the solution on the seal for approximately five minutes.