How do you use AlgerBrush?
To apply the alger brush, approach the eye from the sides, in a tangential manner, rather directly (perpendicularly) on the eye surface. Place the tip of the brush over the discolored portion of the cornea, directly over the rust rings. Press the rotating brush over it.
How do I turn on AlgerBrush?
To start the AlgerBrush II turn end nut in “ON” direction indicated on AlgerBrush II label, i. e. to the right To stop the AlgerBrush II turn end nut in “OFF” direction indicated on AlgerBrush II label, i. e. to the left. To ensure AlgerBrush II is off check that the chuck and burr have stopped spinning.
What does an AlgerBrush do?
An Alger brush is an ophthalmological tool used to remove small foreign bodies from a patient’s eye. It is commonly used to remove rust rings from a cornea.
How do you use a corneal Burr?
The burr is usually mentioned for removal of rust rings but can also be used to remove an embedded corneal foreign body. Gently and briefly press the rotating burr against the foreign body. Then retreat and assess how much was removed. Repeat until the foreign body (or rust ring) is removed.
How do you disinfect Algerbrush?
Completely submerge the device in the cleaning solution and sonicate for at least fifteen (15) minutes. Perform a final thorough rinse of the device and instrument block (if applicable) under running warm tap water for at least one (1) minute.
What is a rust ring in the eye?
A rust ring may form around foreign bodies that contain iron, typically those that are metallic. The salt in tears interacts with the iron in the metal forming rust in the eye just like you see with metal left outdoors in the elements. The reaction begins within 2 to 4 hours of the foreign body embedding in the eye.
Do corneal rust rings need to be removed?
All corneal metallic foreign bodies require prompt removal to avoid the possibility of rust ring formation. A rust ring requires complete removal in a timely fashion in order to avoid the damaging effects of rust on the cornea.
How do you clean Algerbrush?
Completely submerge the device in the cleaning solution and sonicate for at least fifteen (15) minutes. Perform a final thorough rinse of the device and instrument block (if applicable) under running warm tap water for at least one (1) minute. Visually inspect to confirm the removal of debris.
Can you drive after having metal removed from eye?
You will be advised not to drive until the eye patch is removed and your vision has returned to normal. Your doctor will want to see you again to check that your eye is healing and that your vision is all right. You should not miss this appointment. Even though you may feel better, your eye may not have fully healed.