What happens when one brake is stuck on a GMC Sierra?

Pulling to one side – When one brake is stuck (particularly a front brake) the whole vehicle will pull in the direction of the bad brake. So if it is on the passenger side, your Sierra will feel like it is steering in that direction.

Are there different types of front brake rotors?

Kent shows a brief comparison of three different new front brake rotors. You can not necessarily tell the quality by justing looking at one. And, price may not make one better than the other. There are differences in the quality of the castings and coatings as you will see. In the end it may come down to personal preference.

What are the brake lines on a 1988 Silverado?

The first row is for 1988-89 only, after that they went to a 1.25″ width rotor (and a different spindle). The 2000 silverado is included as swapping over the master cylinder seems to be a popular mod (you need a fitting to get the brake lines to thread)

Can a brake rotor be a brake drag?

To correct this, replacement of the rotors and pads will be necessary. This situation could come across as a brake drag but is a drag due to wheel bearings being seized due to a lack of grease or over tightening during installation. The easiest way to diagnose this is to remove the caliper from the rotor and turn the rotor.

Are there front brake discs or rear brake rotors?

However, a lot of vehicles have rear drums instead of brake discs. In this case, the vehicle will have two front brake rotors and two rear brake drums. Types of brake rotors. The vast majority of automotive brake rotors are made from cast iron; however there are many different variations in the design and appearance.

Can you run GMT900 front brakes on a 4×4?

There’s some guys with 4×4’s that are running the GMT800 front spindles which allows them to run GMT900 front brakes (13″ rotors if I recall). I haven’t seen it done on a 2WD, but I’m trying to figure out if it can be done.

How much do brake rotors cost at AutoZone?

Shop AutoZone for GMC Sierra 1500 Brake Rotor. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only

What to do about front brakes on a Chevy Silverado?

SOLUTION; FIRST RAN SEVERAL BOLLLES OF BRAKE FLUID THROUGH SYSTEM ( EQUALLY ON ALL 4 WHEELS). THEN REMOVED ALL WHEEL CYLINDERS; CLEANED, HONED, PUT NEW RUBBERS IN THEM.

Can you replace the master cylinder in a GMC Z71?

DON’T FORGET TO REPLACE THE MASTER CYLINDER ( DON’T RTEBUILD REBUILD IT OR GET A REBUILT ONE– THEY NEVER WORK) [email protected] 22 people found this helpful. 2005 GMC Z71, going through this issue now!!!

What kind of brakes does a Silverado 1500 have?

2006 1500 2 WHEEL DRIVE 4.3L, DRUMS ON BACK, 66325 MILES. The truck has been a reliable work horse up until I replaced the front brake pads, the disk look new at the time, in the 15 mile ride home the front rotor get hot (blue instead of gray) the brakes smell hot and the wheel near the hub will burn you.

How often do front brakes lock up on a Silverado?

Brakes completely lockup, truck won’t move at all. Once it locks up completely, brake pedal is very stiff, takes a lot to depress it. Front wheels get really hot, back wheels feel normal. Brakes will break free after letting the truck sit for about 2 hours, and works fine after. This happens sporadically, once every 2 weeks or so.

What does it mean when your brakes lock up?

The brakes locked up, and I went to the Master Cylinder and loosened the brake line that was closer to the front of the truck (which I believe is the rear brakes). I loosened it enough for fluid to come out, and then all of a sudden the wheels broke free and the truck “rocked” into park.

Why are the brakes on my GMC Sierra not working?

I have an 01 GMC Sierra 2500 (non HD) with 232,000 miles. I’ve been having problems with the brakes lately. Recently, the brakes would not release after you let off the pedal, and continually got worse until you could not physically move the truck.

Why are my front brakes locking up on my Silverado?

The rubber, flexible brake hose attached to the caliper may be deteriorating internally. The hose will not allow brake fluid back out of the caliper when you let off the pedal. As the dragging caliper heats up, the pressure builds. Also, with every stop, the pressure also increases.

Why are the brakes on my GM Truck smoking?

By the time I got off the highway and parked off the road, the rear brakes were smoking. And the brake pedal was as hard as a rock. I could smell the front brakes as well, but they were not smoking. The 2 Brake lights that are on the dash have lit up from time to time, but i have not been able to check the codes, and they only sporadically come on.

Why are the brakes hanging up on my Silverado?

Front brakes are hanging up. I put new pads, new rotors, new calipers and brake hoses and bled the brakes and they are still hanging up and getting extremely hot I need to know if the computer has to be reset for the brakes. How do I get the brakes to release? It is a 2005 Silverado Z71 5.3 liter V8 with rear drums.

Can a caliper not release cause brake drag?

Just like with the master cylinder not releasing causing the brake drag, a caliper not releasing and staying applied can do the same thing. If only one position is dragging, this could be the case.

Navigation