How to replace the rear drive shaft on a Hyundai Santa Fe?
Plug the hole of the transaxle case with the oil seal cap to prevent contamination. Support the driveshaft properly. Replace the retainer ring whenever the driveshaft is removed from the transaxle case. 10. Install in the reverse order of removal.
How do you remove a rear drive shaft?
It did come off like the rear connection to the diff, it just needed some persuasion. It’s a pig to get at but i managet to wedge a chisel between the prop shaft and the flange it mounts onto at the transfer case. A few taps with a hammer and Bob’s your uncle. Ahh now to find a new one.
How do you remove a front drive support bearing?
The front driveshaft is going to be attached solid inside the output shaft supports. In order to remove the driveshaft, you’ll need a rubber or plastic tipped hammer. On the front of the driveshaft is a welding mark that is solid and is the best place to hit with the hammer to loosen the driveshaft.
Where can I get my Hyundai Sonata shaft replaced?
Hyundai Sonata CV Axle / Shaft Assembly Replacement at your home or office. Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing. Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. received a Axle / CV Shaft Assembly Replacement.
Plug the hole of the transaxle case with the oil seal cap to prevent contamination. Support the driveshaft properly. Replace the retainer ring whenever the driveshaft is removed from the transaxle case. 10. Install in the reverse order of removal.
It did come off like the rear connection to the diff, it just needed some persuasion. It’s a pig to get at but i managet to wedge a chisel between the prop shaft and the flange it mounts onto at the transfer case. A few taps with a hammer and Bob’s your uncle. Ahh now to find a new one.
How to remove rear hub carrier from Kia Sorento?
1. Remove the front wheel and tire (A) from front hub. Be careful not to damage to the hub bolts when removing the front wheel and tire (A). 2. Remove the rear brake caliper. 3. Remove the wheel speed sensor (A), from the knuckle. 4. Remove the coking nut (A). The front hub coking nut should be replaced with new ones.
How to replace the rear drive shaft on a Toyota RAV4?
1. INSPECT PROPELLER SHAFT WITH CENTER runout for front side. replace the propeller shaft. shaft, and perpendicular to the shaft. runout for rear side. replace the propeller shaft. shaft, and perpendicular to the shaft. 2. INSPECT JOINT ANGLE the examples below to stabilize each part. hand. lower it.