How many camshaft position sensors are in a Hyundai Elantra?
The Nu MPI 2.0L Atkinson cycle I4 engine is equipped with two camshaft position sensors which are both genuine OEM part number Hyundai 39350-2E200.
How is the crank position determined on a Hyundai Elantra?
Crank or Cam Tone/Reluctor Ring. The Crankshaft Sensor is going to use a tone or reluctor ring to determine the position of the Crank. This ring uses notches that are scanned by the Crank Sensor in order to get an accurate position. If this ring fails, the Elantra will not be able to get an exact crank position.
Why does my Hyundai Elantra engine not run?
The crank and cam sensors work in tandem to produce the ideal air/fuel ratio for your engine. When this timing is off, the engine will typically not run (or barely run). Here are the major symptoms of P0017 in the Elantra: Here are the most common causes of P0017 in the Elantra, as well as diagnostic advice, and resources to further explore.
Is there a p0017 sensor on my Elantra?
A lot of the harness leading to and from the Crank/Cam sensors is going to be exposed to hot exhaust and vibration. This is a great place to start diagnosing P0017 in your Elantra.
How does the timing of the intake cam work?
The timing of the intake cam is varied by the relative operation the CVVT vane to the housing. The CVVT controller regulates the intake camshaft angle using oil pressure through the OCV (Oil Control Valve).
Where is the camshaft position sensor located on a Hyundai?
The budget option, covered by our Lifetime Warranty. Cut repair costs, not quality. elynbert, the camshaft position sensor monitors the position of the camshaft. It is mounted at the right hand side (looking from the front of the engine)of the cylinder head.
Where is the intake CMP located on a Hyundai Sonata?
Intake cmp is on the front of the engine just below the valve cover almost even with the right side of the manifold. The exhaust cmp sensor is in the same location on the backside of the head. Was this answer helpful? I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor.
What are the components of the Hyundai Elantra?
Multi-Purpose Check Connector [20-Pin] 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Position Sensor (TPS) 16. ETC Motor
Where is the camshaft position sensor on a Honda Accord?
elynbert, the camshaft position sensor monitors the position of the camshaft. It is mounted at the right hand side (looking from the front of the engine)of the cylinder head. You should make out the plug with the wire and see that the sensor is being mounted with 1 10mm bolt. 1. Disconnect negative battery cable. 2.