When did the first Corvette LT1 come out?
The first LT1 was put in the 1992 Corvette. Then in 1993 the LT1 was introduced in the Camaro/Firebird. 1992-1993 LT1 were mated with 700R4’s. The ECM for the 92-93 had a removable MEMCAL that housed the EPROM that stored calibration information. The ECM’s have 4 square plugs, and the ECM case is black in color.
What is the service number on a corvette 94-95?
This is the electronically controlled transmission. The 94-95 PCM’s are identified by service number. 16188051. Corvette 1994/1995 may have used Serv. No. 16181333. All 94+ LT1 PCM’s are aluminum in color with 4 rectangle plugs. 94-95 PCM’s can be flashed through the diagnostic port using rather inexpensive hardware and software.
Do you need to replace a wire harness on a 96 car?
A module has been included to bypass the vehicle anti-theft system (VATS) incorporated in the computer. When using this harness on a ’96 or ’97 engine you must replace the coil, coil output wire with the parts from a ’92 – ’95 engine.
What kind of ECM does a 1992 LT1 have?
1992-1993 LT1 were mated with 700R4’s. The ECM for the 92-93 had a removable MEMCAL that housed the EPROM that stored calibration information. The ECM’s have 4 square plugs, and the ECM case is black in color. 1994 started first year for 4L60E as the automatic trans option. This is the electronically controlled transmission.
What kind of wiring does a Corvette LT1 use?
1994-1997 LT1 From Roadmaster, Camaro, Corvette, or Cadillac Made from premium grade GXL jacketed automotive wire Most wiring is larger gauge than stock application for durability All primary grounding is done at the head or block and grounding points are isolated from each other to reduce electrical interference and minimize ground looping
Which is the best wiring guide for LS engines?
LS SWAPS: Wiring Harness and Wiring Guide Includes in-depth instruction and photos. Covers all the criteria to consider when starting an LS swap project LS Engine DIY Do It Yourself LS Engines LS SWAPS: Wiring Harness and Wiring Guide March 10, 2015by LS Engine DiY The wiring aspect of any LS swap is undoubtedly the most difficult.
When to replace the wiring on a corvette?
With 40-plus-year-old wires, often the best solution is total replacement, especially if the car is apart already. The crew at Red Dirt Rodz handled all of the wiring details for this 1967 Corvette roadster. This car came into the shop as many do, fully disassembled, as one person’s failed build sold off to another.
Can a C4 transmission be used on a LS1 / 2 corvette?
This transmission is a direct bolt up application to the LS1/2 assembly. However, the tail shaft housing is not compatible with the C4 C beam housing. While it is possible to use a stock C4 transmission, other considerations would have to be made for the torque converter and mounting bolts.