How do you adjust the speed of a gas golf cart?
Tighten the governor spring located in the engine of most golf carts to adjust your cart’s top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.
Why is my club car so slow?
Low Battery Usually, the most common reason golf carts slow down is when they don’t get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How can I make my 36 volt club car faster?
How to Make a 36 Volt Golf Cart Faster
- Remove any unnecessary additions, racks or parts on your golf cart.
- Power-wash your cart.
- Check the shaft under the ignition pedal.
- Put larger tires on the cart.
- Replace any old or worn-out parts that are causing the cart to move slower than it should.
Why is my gas golf cart slow?
How fast can a gas golf cart go?
What is the Average Golf Cart Speed? The average top speed of a typical golf cart without any upgrades is between 12 and 14 miles per hour. Without any sort of modification or upgrade on a golf cart, the top speed that you will be getting on a golf cart is about 14mph.
What is speed code 4 Club Car?
Speed code 4 just allows the motor to run at a higher RPM. It does nothing to increase power or any other aspect of the system. It just raises the rev limit. The Club Car system will allow you to enter the controller serial number along with the vehicle serial number.
How do you remove the speed limiter on a club car?
Look behind the governor to find a small metal rod that’s permanently attached to the club car and stretch your rubber band enough to connect it to that metal rod. Screw the plastic plate back in place. Once the plate is back in place, the governor is disabled.
Where is the governor on a Club Car golf cart?
Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor.