Why does my Hyundai Santa Fe make a whining noise?

The dealership replaced the front ball joints. A week after they did that, it started making a whining sound. Again, it doesn’t do it all the time, mostly when it is cold. It stops after a few minutes. I do not have a trailer hitch on my Sante Fe.

Are there any recalls on Hyundai Santa Fe SUVs?

17,618 Santa Fe Sport SUVs built in Georgia from Aug. 10, 2017, through Oct. 24, 2017. The problem: These SUVs have steering wheel hub assemblies that have been manufactured without enough breakage strength, increasing the risk that the steering wheel could separate from the steering column while someone is driving, Hyundai says.

Why does my Sante Fe make a clunking noise?

My Sante Fe makes that bouncing clunking noise during normal driving and while going over uneven roads and/or bumps. But it doesn’t do it all the time. The dealership replaced the front ball joints. A week after they did that, it started making a whining sound. Again, it doesn’t do it all the time, mostly when it is cold.

Is there a recall on Hyundai steering wheel?

The fix: Hyundai dealers will check the production lot number of the steering wheel assembly and replace it if necessary, free of charge. How to contact the manufacturer: Owners can call Hyundai customer service at 855-371-9460. Hyundai’s number for this recall is 173. NHTSA campaign number: 18V118000.

How do you lower the headrest on a Hyundai Santa Fe?

To Lower Headrest: Press lock button while pressing down on headrest. To Adjust Headrest Forward: Pull forward to 1 of 3 positions To Adjust Backward: Press lock button and push headrest backwards. SEAT BELT ADJUSTMENT (Front seat) Pull up to raise. Press button and push down to lower.

Are there any problems with the Hyundai Santa Fe?

After talking to a hyundai sales rep these tranny and drive shaft problems are on the 2010 4cyl and 6cyl models so far. This engine and trany are both new to hyundai. best of luck!!! I had a “New” transmission installed in my 2010 Santa Fe and it has the same problems as the original one.

What kind of car is a 2004 Hyundai Santa Fe?

I traded in a 2004 AWD Santa Fe with 93,000 miles and never had a problem except for a $400 sensor – which caused the transmission to slip. Interesting. I loved my 2004 and that’s why I decided to stay with Hyundai.

Why does my Hyundai Santa Fe make a knocking noise?

While driving along the highway about 70-75 mph I started to hear a knocking sound, I began to slow down and the noise continued every time I accelerated. There were no dash lights displayed the entire time. All of a sudden I hear a bang and had complete engine failure.

When did the Hyundai Santa Fe engine start to slow down?

On September 1, 2020, the engine started to slow down and make a crunching cracking noise about a mile later we came to a complete stop, on a main hwy. We had to call aaa to come get us.

What causes a Hyundai Santa Fe engine to overheat?

Radiator house clip appears to have been missing from the factory causing the hose to finally come lose resulting in a coolant loss and overheating. Replacement of the belt tensioner. 290-horsepower 3.3L V6 6-speed shiftable automatic FWD

Where can I get a Hyundai Santa Fe engine replaced?

The contact stated no warning light was illuminated. The vehicle was towed to local dealer (major Hyundai 1534 n 9th st, stroudsburg, PA 18360 (570) 972-2578) where it was diagnosed with needing engine to be replaced.

Why does my car make a scraping noise when I turn a corner?

If your vehicle makes a scraping noise that sounds like something being dragged across a tin plate while driving or when turning a corner, it’s possible you have picked up a rock from a dirt road or a freshly repaired pothole—the kind of place where you hear a shower of pebbles hitting the bottom of your car as you drive through.

Why does my Hyundai Santa Fe creak when I turn the steering wheel?

received a Creaking noise when turning the steering wheel Inspection. Hyundai Santa Fe Creaking noise when turning the steering wheel Inspection costs $85 on average. Under ordinary circumstances, turning your steering wheel shouldn’t cause any unusual noise. It should simply direct your car in the direction you want to go.

When does Hyundai Santa Fe come to inspection?

Hyundai Santa Fe Clunking or knocking noise from wheels Inspection at your home or office. Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM. Our certified mobile mechanics can come to you now.

Can a bad wheel bearing cause a Hyundai Santa Fe to lock up?

It is not recommended to drive your Hyundai Santa Fe on a bad wheel bearing. They are dangerous. As they go bad they create heat. This heat can eventually cause the tire to lock up while going down the road. Replacing a wheel bearing is not that expensive, even if you take it in to a shop.

How can I tell if my Santa Fe has bad bearing noise?

Test Drive – The best way to diagnose bearing noise in your Santa Fe is to take it for a drive. You’ll be looking to hear the hum increase as the speed picks up. Jack and Wiggle – With your Santa Fe on jack stands, you’ll want to look and see if the wheel is wiggling at the bearing.

What makes a grinding noise when you turn the steering wheel?

The grinding noise happens when there is no brake pad material remaining and the metal backing plate contacts the metal brake rotor. When the power steering fluid is low there is a moaning/grinding noise that is heard when turning the steering wheel. This noise comes from air bubbles in the power steering fluid.

Why does my Hyundai Santa Fe make a high pitched noise?

If your Hyundai Santa Fe is making a high pitched noise or hum, it could be a sign of a bad wheel bearing. There are several different vehicular components that can make a squeal or hum. That’s why it is important to know the other warning signs of a bad bearing before just going in and replacing it.

What does it mean when a Hyundai Santa Fe wheel goes bad?

Do something for us. Around 88K miles, there was some whirring/grinding noise (bearing noise is distinct, but hard to explain). Noise would appear/disappear based on load. The bad bearing is on the driver’s front. Left turns eliminate the noise while right turns worsen it. The noise echoes throughout the cabin and the wheel vibrates at speed.

When does wheel bearing noise get worse in a Santa Fe?

Worse When Turning – Wheel bearing noise will often get worse when you turn. This is particularly true when it’s the front bearings that have gone bad. Louder With Speed – Typically, bad wheel bearing noise will increase as you increase your Santa Fe’s speed.

Why does my car make a grinding noise when I Turn It?

Sometimes the drivers hear grinding noise while turning the car. A worn CV axle, worn brake components, a power steering fluid leak are the major causes of producing a grinding noise. When the car makes any type of abnormal sound,it is a matter of concern.

Hyundai Santa Fe Whining sound when car is in gear Inspection costs $85 on average. Your transmission is responsible for making your car move – it transfers the power from the engine to the wheels. During normal operations, you’ll definitely hear at least some noise.

Also please check out the statistics and reliability analysis of Hyundai Santa Fe based on all problems reported for the Santa Fe. The fuel gage is broken, it reads empty when full. The abs light came on and took it in to fix it. $400. 00 later it was fixed.

What kind of car has a popping noise?

I just wanted to share my scary story. Tl- the contact owns a 2013 Hyundai Santa Fe sport. The contact stated that while driving approximately 65 mph a loud popping noise suddenly occurred and smoke was seen coming from the hood of the vehicle. After lifting the hood flames were present coming from the engine.

Why does my car whine when I put the car in gear?

Low Transmission Fluid: For both manual and automatic transmissions, the primary cause for whining when in gear is low transmission fluid. If the fluid is too low, then the internal components of the transmission are not lubricated properly. What you’re hearing is actually friction between those parts, and it can lead to significant damage.

Are there any recalls on the 2007 Hyundai Santa Fe?

Based on information received from our latest subscriber survey, our reliability history charts give you a rundown on how used vehicles are holding up in 17 potential trouble spots, ranging from the engine, transmission, and brakes to power equipment and the electrical system. The 2007 Hyundai Santa Fe has been recalled 9 times by NHTSA.

Why does the radiator fan on my Hyundai Santa Fe keep running?

The radiator fan on my 2010 Hyundai Santa Fe keeps running after the engine is off. How do I get it to turn off? The radiator fan on my 2010 Hyundai Santa Fe keeps running after the engine is off.

What should I do if my Santa Fe fan is not working?

The fan wiring is some of the more vulnerable wiring in your Santa Fe. You can test the voltage going from the fan relay to the fan itself. If it is getting 12+ volts, the fan should be coming on. But if it’s not, which means the fan has gone bad.

Why does my Hyundai Santa Fe make a noise when I start it?

When I start the engine for the first time after it sits overnight, I definitely hear a ZZIINNNGGG noise from the starter at the end of the cycle. When the engine throws the starter back out after it has turned over. It sounds like it is spinning.

The radiator fan on my 2010 Hyundai Santa Fe keeps running after the engine is off. How do I get it to turn off? The radiator fan on my 2010 Hyundai Santa Fe keeps running after the engine is off.

Hyundai Santa Fe owners have reported 30 problems related to engine noise (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Hyundai Santa Fe based on all problems reported for the Santa Fe.

What kind of engine does the Hyundai Santa Fe have?

The crankshaft position sensor failure affected quite a few engines in the Santa Fe lineup, including Hyundai’s 2.0-liter four-cylinder, 2.4-liter four-cylinder turbo, 2.7-liter V6, 3.3-liter V6, and 3.5-liter V6 engines. The problem occurred at an average mileage of 103,710 miles.

Why does my Hyundai make a clicking noise when turning?

The problem is caused by a flexible rubber coupling. Hyundai has issued a service bulletin 14-ST-002-1 to address the problem on the vehicles listed below. The noise does not affect steering. The new flexible coupling is part # 56315-2K000-FFF

What makes a clicking noise when you turn the steering wheel?

turning the steering wheel. The noise has also been described as a thud. The problem is caused by a flexible rubber coupling. Hyundai has issued a service bulletin 14-ST-002-1 to address the problem on the vehicles listed below.

Why does my Hyundai Santa Fe make clicking noises?

The contact stated that while driving at various speeds there was an abnormal clicking noise detected. There were no warning lights illuminated. The vehicle was taken to an independent mechanic who stated that the failure was due to the engine and referred contact to a local dealer.

What kind of noise does a Santa Fe make?

I have a 2004 Santa Fe that I purchased used about 3 months ago. Just recently there has been a very annoying knocking noise coming from the passenger side of the dash. The noise happens more often if I hit a bump in the road but sometimes all I have to do is back up to hear it.

Is there a vibration in my Hyundai Santa Fe?

I swear the vibration disappeared for a while, then came back intermittently, after everything had settled down.

Where can I buy used Hyundai Santa Fe parts?

Find guaranteed used Hyundai Santa Fe parts here for low prices. Our extensive range of Hyundai Santa Fe breaking vehicle parts and spares will beat all Hyundai Santa Fe dealer prices. We are the cheapest place to buy quality used Santa Fe parts in the UK with savings of up to 90% vs new!

What kind of noise does a Hyundai Santa Fe make?

The contact owns a 2001 Hyundai Santa Fe. The contact stated that while driving at 10 mph, the contact heard an abnormal popping sound coming from the rear of the vehicle. The contact drove back to her residence where her husband inspected the vehicle.

What was the worst problem with the Hyundai Santa Fe?

Worst 2010 Hyundai Santa Fe Problems #1: Engine Failed 2010 Santa Fe Average Cost to Fix: $8,000 #2: Engine Stalls/Shuts Off While Driving 2010 Santa Fe Average Cost to Fix: N/A #3: Spring Broke While Driving 2010 Santa Fe Average Cost to Fix: $1,500

What are the features of a Hyundai Santa Fe?

The Santa Fe’s already long list of standard comfort and convenience features also grows a little longer for 2010.

What’s the difference between a Santa Fe and a GLS?

The Limited’s sunroof and audio system are optional on the GLS and SE, as are heated front seats (SE only) and a navigation system with rearview camera. The 2010 Hyundai Santa Fe gets two new engines and six-speed transmissions that deliver both better performance and improved fuel economy.

Why does my Hyundai Elantra make a clunking noise?

If a ball joint is beginning to fail, you may notice a clunking noise coming from the front wheels. This clunking noise will become louder and more frequent over time.

Hyundai Santa Fe Clunking or knocking noise from wheels Inspection costs $89 on average. Clunking or knocking noises can be very disconcerting for any driver to hear while they are going down the road. While these noises may be a symptom of some different issues, all are usually related to a suspension component that has failed.

If a ball joint is beginning to fail, you may notice a clunking noise coming from the front wheels. This clunking noise will become louder and more frequent over time.

Why does my Hyundai make a clicking noise when I reverse?

We isolated the noise to the outer tie rod ends but the vehicle had to be sitting for a few hours to make the popping/ clicking noise, there was also no visible play or cracking boots. Going with what alz99 said, take the vehicle to a reputable shop that wont drag it through the parts department.

Navigation