How do you move underground sprinkler lines?
How to Move a Sprinkler System Line
- Plan the New Sprinkler Line Layout.
- Locate the Origin of the Line.
- Dig a Trench to Excavate the Line.
- Remove the Pipe and Sprinklers.
- Lay Out Pipe and Mark the New Line.
- Dig the New Trench and Insert Pipes.
- Remove Sprinkler Heads and Flush Pipes.
- Replace Soil and Test the Pipes.
Can you relocate sprinkler heads?
Any head can be moved by as much as four feet using flex pipe, which you can find plumbing and irrigation store. If you are relocating your sprinkler head more than a few feet away, consider using painting tape to outline your route before you start digging the trench.
How deep are sprinkler lines Minnesota?
How deep should the trenches be? (Most building codes require you to dig down 18 inches to protect the water lines from freezing — in colder climates the required depth is more.) Unless you relish the idea of hand-digging several hundred feet of trench, rent a gas-powered trenching tool for $100–$160 per day.
How much does it cost to relocate a sprinkler head?
On average, sprinkler head replacement costs between $65 and $90 to hire a professional, or $2 to $12 per head if you replace them yourself. The cost to install additional sprinkler heads is between $94 and $103. Replacing or relocating sprinkler heads for your entire lawn will cost about $400.
How much does it cost to reroute sprinklers?
Replacing a sprinkler system timer costs $40 to $450, plus labor. Your pro may only need to reprogram or rewire this component instead of replacing it, at an average rate of $50 to $100 per hour. Putting in new wiring for the sprinkler system ranges from $0.50 to $1.50 per foot, in addition to labor charges.
How deep do you bury underground sprinkler lines?
Riser Depth If you want to bury your line in a more shallow trench, purchase risers that sit flush between the sprinkler and the supply line. To bury sprinkler lines deeper for better insulation from the cold, purchase risers that are between 6 and 12 inches long.
How deep are sprinkler pipes buried?
8 to 12 inches
Basic Depth Requirements In most areas, burying the pipes 8 to 12 inches below the surface is adequate. This measurement is from the top of the pipe to the surface of the soil, which means your trenches must be slightly deeper to accommodate the pipes.
How much do underground sprinklers cost?
An underground sprinkler system costs anywhere from $1,740 to $3,400 to install on a one-quarter acre residential lawn. Larger lawn areas and yards with multiple zones will cost more to irrigate. This project requires you to pay the cost to dig a trench, purchase materials and complete the installation.
Is it easy to move an inground sprinkler head?
Moving an inground sprinkler head is not a difficult task, and it is an important one to learn because it means the difference between an unchanging landscape and one that can grow and change over time. Decide which sprinkler head needs to be moved and where the best new location will be.
How big of a trench do you need for a sprinkler system?
Dig a trench between eight and 12 inches deep and four to six inches wide, running from the current location of the sprinkler head to the planned location. Make sure that you turn the irrigation system off at its controller at this point.
How do you remove a sprinkler head from a pipe?
Measure your trench and cut a length of 3/8-inch flex pipe a few inches longer than this measurement. It is always smart to leave a little extra, just in case. Next, unscrew the sprinkler head from its riser, and unscrew the riser from the pipe to remove the entire framework of the sprinkler head.