What length should I cut my starter shingles?
Cut 12 inches (30.4 centimeters) off the length of the first shingle that you lay. Then lay down whole tiles to the end of the row, trimming the last shingle so that it fits correctly.
Do you overlap starter shingles?
With the starter shingles laid along the very edge of the roof, run a set of starter shingles along the sides of the roof as well, making sure that those rows come down and overlap the starter shingles you laid at the bottom.
What is the price of Timberline shingles?
Cost Of GAF Shingles At Home Depot
| Type of Shingle | Price per sq.ft. | Price per bundle |
|---|---|---|
| Timberline Natural Shadow (laminated) | $0.87 | $29 |
| Timberline HD (laminated) | $0.93 | $31 |
| QuickStart Peel and Stick Starter Shingle Roll | n/a | $19.98 / box |
| Pro Start Eave and Rake Starter Strip Shingles | $1.10 | $36.97 |
Can I use 3 tab shingles for starter?
A lot of roofers claim you don’t need to use officially designated starter strip shingles and instead opt for using repurposed 3-tab shingles as the starter strip. Starter shingles should always overhang the eave and rake edges of the roof by about 1/4″-3/4″ to ensure adequate rain water drainage.
How far should shingles overhang the rake?
The edge of the shingles should hang over a roof between an inch and an inch and a half — or between a half inch and three-quarters of an inch if drip edge flashing is installed. Too much overhang and the shingles could blow off in high winds; too little can allow water to seep into rake or fascia boards.
Should shingles be flush with drip edge?
How Should Shingles Be Installed Over Drip Edge? Shingles should be installed over the drip edge a minimum of 3/8” (9 mm) at both the eave edge and the rake edge. out from the rakes and eaves (typically called DL Style or D Type), the shingles may be installed flush with the drip edge.
Which is better starter strips or starter shingles?
GAF – Mastering The Roof (chapter 09) This video demonstrates the proper installation technique for GAF starter strips; a superior alternative to starter shingles. Starter strips are important for wind resistance. Use WeatherBlocker or ProStart starter strips.
Where to put starter strip on GAF shingles?
GAF offers increased wind speed coverage on many GAF shingles when Pro-start eave/rake starter strips are installed and special installation requirements are met GAF recommends installing Pro-start eave/rake starter strip at both the eave and rake edges of the roof
What makes pro start eave / rake shingles so good?
Pro-Start ® Eave/Rake Starter Strips are made with a high-quality, properly positioned adhesive applied at the factory to help prevent shingle blow-off. Plus, installers like that they’re easy to use with no cutting on the roof, while homeowners feel good about the fact that they create less waste.
How to set your preference for Angel SpeedPro?
You can simply change the indicators and set your preference for your profile. You set your preference for markets, mutual funds and stocks that you want to track on a daily basis. You can also customise the reports that Angel SpeedPro generates for you.