How do I change the oil in my transfer case?

How do I change the oil in my transfer case?

Difficulty

  1. Secure the vehicle on a level surface.
  2. Locate the oil fill plug on the transfer case.
  3. Remove the top oil fill plug.
  4. Using a flashlight, check for oil at the fill plug hole.
  5. With the top oil fill plug still out, remove the bottom oil drain plug to drain the oil into an oil drain pan.

How to change rear differential and transfer case fluid?

1. This process is largely the same as the rear differential, start by breaking loose the fill plug, its to the right of the drain plug, followed by the drain. 2. Let all the oil drain out, replace the washer and reinstall and tighten the drain plug. 3.

How to get oil out of transfer case?

2.Break the FILL PLUG loose FIRST. if you break the drain plug loose first, drain everything out and find out you can’t get the fill off, you’re in big trouble. 4. Let the oil drain out, 10-15 minutes for everything, mine still had a drip at this point but it was empty enough. 5.

How often should I change my transfer case oil?

Depending on your specific usage, your intervals for changing transfer case gear oil will range from approximately 30 to 60 thousand miles. For that service interval, the cost of purchasing the more expensive Toyota fluid is worth it.

Where is the transfer case on a RAV4?

The transfer case is located to the left of the oil pan. Easy to spot since the driveshaft runs from it to the rear differential. The Fill Plug is located on the drivers side of the transfer case. It takes a 10 mm hex socket and some muscle to remove.

Why do I need to change my transfer case oil?

The products of wear mix with oil, and this causes gears and other internal components to wear faster. Toyota transfer case drain plug and fill plug. In many cars, a transfer case is located close to hot exhaust components; the heat also causes the fluid to deteriorate sooner.

How can I change the fluid in my transfer case?

Your mechanic can check the fluid condition first and change it if it’s dirty. The transfer case or unit usually has two plugs: a fill plug above and a drain plug below. The fluid level and condition can be checked through the fill plug.

When to check for oil leak in transfer case?

A transfer case also should be checked regularly for leaks. Leaks should be repaired as soon as possible. The first sign of a leak is a gear oil smell coming from under the vehicle and drops on the driveway.

Can a Toyota transfer case drain plug be changed?

The simple answer is no. Any mechanical device with moving or rotating parts wears out. The products of wear mix with oil, which causes the gears and other components to wear even faster. Toyota transfer case drain plug and fill plug.