What is a Hyundai VCM motor?
It consists of a DC motor which actuates the VCM valve and a position sensor which detects the position of the VCM valve. The VCM system tumbles air flow entering into combustion chamber of each cylinder by closing the VCM valve in the cold start conditions.
What does a VCM motor do?
VCM (Variable Cylinder Management) is fuel-saving technology that automatically deactivates 1/3 or 1/2 of the cylinders, according to the driving conditions. This saves fuel and lowers emissions.
How much does it cost to repair a p200a Hyundai?
The cost of diagnosing the P200A HYUNDAI code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What does check engine light on Hyundai p200a mean?
In addition to the check engine light, you may also notice a slight hesitation or reduced power during acceleration, an automatic transmission upshift hesitation during acceleration, and a clicking noise from the intake manifold VCM (Variable Charge Motion) actuator when the engine RPM is increased.
What does code p200a mean on OBD II?
If your OBD II equipped vehicle has stored a code P200A, it means that the powertrain control module (PCM) has detected a problem with the intake manifold runner control (IMRC) system. Code P200A applies explicitly to the bank of the engine that contains the number one cylinder.
How to diagnose p200a Hyundai intake manifold runner?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals. What does this mean? The cost of diagnosing the P200A HYUNDAI code is 1.0 hour of labor.
Is there a problem with the Hyundai p200a?
Hyundai has issued a service bulletin # 16-01-004-2 to address the issue on the 2.4 GDI equipped vehicles listed below. Here’s how to deal with the problem. Hyundai has issued a software update to deal with a Hyundai P200A (Intake Manifold Runner Performance – Bank 1) trouble code.
If your OBD II equipped vehicle has stored a code P200A, it means that the powertrain control module (PCM) has detected a problem with the intake manifold runner control (IMRC) system. Code P200A applies explicitly to the bank of the engine that contains the number one cylinder.
How can I tell if my Hyundai Sonata is working?
2015-16 Hyundai Sonata vehicles with the 2.4L GDI engine The service bulletin advises checking the variable charge motion activator (VCM) to determine if it’s working properly. To do that, check the actuator sensor voltage on terminal 5 at the VCM connector with the engine running.
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals. What does this mean? The cost of diagnosing the P200A HYUNDAI code is 1.0 hour of labor.