Where is the fuel filter on a 2013 Honda Foreman 500?
On the 13 model it’s inside the sub fuel tank.
How do you remove fuel filter from Honda?
Remove the 4 screws on the top of the carb and pull out the throttle plunger. Use a philip screwdriver and insert it into the holder (middle of slide) and give it a 1/4 turn and remove the holder. The needle should fall out now and either the washer will be on the needle or it will stick to the slide/plunger.
Can you replace fuel filter off of vacuum?
Yes replace it but for the time being if you want to use the machine use a little super glue and glue it back together. Yes, it’s off of vacuum so the plunger isn’t raising like it should. Thanks a lot man.
Where is the fuel filter on my 420 rancher?
Tried replacing the plug today but that wasn’t the prob on my 420 rancher. It starts missing and stalling everytime after about 15 mins of running. I had it on reserve before this happened so it might of picked up dirt. But the manual doesnt say anything about the filter. Is it inside the pump housing? If so do i need to replace the whole unit?
Where is the fuel mixture screw on a Honda Foreman?
The pilot (air/fuel) mixture screw is the one on the bottom of the carb at the front of the bowl and in the center of the carb. It is in the cylinder piece sticking down from the carb. Alright your help so far has been amazing man and you don’t know how much I apreciate it.
Remove the 4 screws on the top of the carb and pull out the throttle plunger. Use a philip screwdriver and insert it into the holder (middle of slide) and give it a 1/4 turn and remove the holder. The needle should fall out now and either the washer will be on the needle or it will stick to the slide/plunger.
Tried replacing the plug today but that wasn’t the prob on my 420 rancher. It starts missing and stalling everytime after about 15 mins of running. I had it on reserve before this happened so it might of picked up dirt. But the manual doesnt say anything about the filter. Is it inside the pump housing? If so do i need to replace the whole unit?
Yes replace it but for the time being if you want to use the machine use a little super glue and glue it back together. Yes, it’s off of vacuum so the plunger isn’t raising like it should. Thanks a lot man.
The pilot (air/fuel) mixture screw is the one on the bottom of the carb at the front of the bowl and in the center of the carb. It is in the cylinder piece sticking down from the carb. Alright your help so far has been amazing man and you don’t know how much I apreciate it.