What are the specs of a CR500 bike?
CR500 SPECS. 85-88 bikes had 60-64 HP. Late 90s through 2001 mellowed out to 56HP. about 222 pounds dry weight. 38mm flatside carb. 491cc 2 stroke. 89mm x 79mm bore and stroke. 6:7:1 compression ratio. 5 speed transmission.
How tall is a 1986 Honda CR500 jetting guide?
Our 1986 CR500 at 3500 FEET, 2nd Clip DOWN – Stock Needle – PWK Carb – 40:1 PREMIX runs a 185 MAIN when below -20C. At about -15C We will run a 182 -5c to -10c We will go 178 to 175 MAIN Jet.
When did the Honda cr500r 88 come out?
The CR500R’88 was sold in 1988 in Fighting Red. The “CR500” and wing decals on the tank shroud were solid white. The seat and fork boots were red. The wheel rims were silver. The front forks had cartridge damper assemblies. The rear section of the frame was detachable. The rear brakes were disc. The carburetor used a flat slide.
What should mix ratio be on Honda CR500?
However, depending on the racing and RPM you are at, this can determine if your engine will be at 20-30HR engine or an 80-100hr Engine. More Lube= less wear on bearings, engine runs cooler, just like in the bedroom. 40:1 or 32:1 Mix Ratio is an industry standard and for good reason.
How big is a Honda CR500 dirt bike?
The bike weighed just 238.1 pounds (108.0 Kg). The Honda CR500 is a large displacement 500cc motocross / enduro dirtbike made by Honda since 1984. 1984 1984 Honda CR500R
What was the name of the 1989 Honda CR 500R?
The 1989 CR500R came in Fighting Red. The gas tank shroud sported a new style wing in solid white. The “CR” logo was found on the side of the seat. The front forks featured inverted cartridge type. The rear section of the frame was detachable.
Our 1986 CR500 at 3500 FEET, 2nd Clip DOWN – Stock Needle – PWK Carb – 40:1 PREMIX runs a 185 MAIN when below -20C. At about -15C We will run a 182 -5c to -10c We will go 178 to 175 MAIN Jet.
What kind of engine does a Honda CR 500R have?
Honda CR 500R Make Model Honda CR 500R Year 1989 Engine Two stroke, single cylinder, membrane & Capacity 491.4 cc / 29.9 cu-in Bore x Stroke 89.0 x 79.0 mm