What is a drain bolt?
The oil drain plug is a threaded bolt made from a soft metal (like aluminum) with a sealing gasket tightened to the bottom or side of the engine oil pan. When the threads on the plug or pan get stripped, or the gasket breaks, oil will leak.
What kind of oil goes in a Honda Shadow?
NOTE: The Honda Shadow takes 2.6 quarts of 10W-40 oil.
Can I just add oil to my motorcycle?
On this bike you check the oil while balancing the bike upright. Keep it reasonably near the marks just don’t accidentally overfill because you were reading the level wrong. Mixing oil is fine but no sense using expensive stuff if you’re just topping up.
How often should I change my engine oil motorcycle?
Motorcycles needing semi-synthetic motor oil can usually last between 5,000-8,000 miles before needing to change the oil. Finally, motorcycle engines running off fully synthetic motor oil will be able to last between 7,000-10,000 miles before needing to change the oil.
Where is drain bolt on Honda Shadow 750?
Find the drain bolt, which is located on the underside of the motorcycle. Next, get a drain pan ready and remove the bolt with a 17mm wrench to drain the oil. NOTE: Keep track of the drain bolt crush washer. If it’s missing or damaged, you’ll need to replace it. Use our Honda Shadow crankcase parts diagram if you can’t find the drain bolt (#21).
How to change oil on Honda Shadow VT750?
Take the bike for a 10 minute ride to warm up the engine oil. Place the bike on a lift or side stand. Remove the drain plug with a 17mm box wrench or socket. Let the oil drain for 5-10 minutes. If needed, install new crush washer and reinstall drain plug.
How do you remove gas tank from Honda Shadow?
How to Remove a Honda Shadow Gas Tank. Unbolt the two bolts on the side of the frame using a 3/8-inch ratchet and socket. Pull the seat up and away from the frame. Unbolt the rear-most section of the gas tank from the frame using a 3/8-inch ratchet and socket. Place a drain pan underneath the gas tank to catch any runoff.
How big is the drain plug on a Honda washer?
To ensure reliability, purchase Honda part # 94109-14000 Washer, Drain Plug (14MM) . It is sometimes referred to as Honda Drain Plug Washer. Our Honda parts and accessories are expedited directly from authorized Honda dealers strategically located all across the U.S. and are backed by the manufacturer’s 12 month, 12,000 mile warranty.
Find the drain bolt, which is located on the underside of the motorcycle. Next, get a drain pan ready and remove the bolt with a 17mm wrench to drain the oil. NOTE: Keep track of the drain bolt crush washer. If it’s missing or damaged, you’ll need to replace it. Use our Honda Shadow crankcase parts diagram if you can’t find the drain bolt (#21).
Are there any aftermarket parts for a Honda Shadow?
Along with custom and OEM parts, we carry a full line of Honda Shadow aftermarket parts from top bike brands, as well as OEM parts for your ride. The Shadow has been a popular model for many years.
Where is the oil filter on a Honda Shadow 750?
The Shadow 750 oil filter is located near the rear tire. Step 6. Smear a little oil around the seal at the top of the O-ring on the filter to make it easier to remove next time. Step 7. Replace the old oil filter, and torque the new oil filter to 19 foot-pounds. Step 8. Refill the engine with oil.
How much oil does a Honda Shadow take?
NOTE: The Honda Shadow takes 2.6 quarts of 10W-40 oil . Step 9. Replace the fill cap/dipstick once you’re close on the oil level, and run the engine for a minute or two to circulate the new oil. Step 10.