Can you use a 700R4 without a computer?

Can you use a 700R4 without a computer?

To run a 700-R4 trans behind a carbureted engine without a computer, at the very least the TV cable must be hooked up to the carburetor and properly adjusted. Not just a simple kickdown cable like your TH350 analogue, the TV cable controls line pressure and shift points.

How much power can a stock 700R4 handle?

The Street/Strip 700R4 is good for about 550 hp maximum, but with the HD input drum it is good for about 625 hp max.

Are all 700R4 lockup?

Every 700r4 is a lockup transmission.

Can you replace a TH350 with a 700R4?

This swap is possible, most go the other way TH350 to 700R4. Driveshaft length needs to be adjusted. Shift linkage will need to be corrected, I recommend getting an aftermarket floorshifter it makes the swap easier.

How to swap a 400 transmission to a 700R4?

Swap a 400 transmission with a four inch tail to a 700R4 transmission: #1. The drive shaft will need to be cut and a smaller yoke installed. #2. The cross member can be used in the same location, if you use a special 700R4 tail housing. Our #49 700R4 tail housing with transmission mount (7 3/8 inches long).

How much does a 700R4 conversion kit cost?

Starting at $2407.00 700R4 Conversion Kit for Early GM Cars and Trucks in 5 700R4 Levels and Price Points. Complete with everything but the driveshaft. You pick the power level for the transmission and the crossmember is determined by the vehicle type.

When was the last car with a 700R4 transmission?

The 700R4 transmission was used in cars between 1982 and 1993. Specifically, it could be found in trucks and rear-wheel-drive cars including: That being the case, the widespread use of the 700R4 (4L60) was 1992. Also, the 1993 Corvette, Camaro, and Typhoon were the vehicles to feature the last production of the 700R4.

What kind of metal is the 700R4 transmission made out of?

The 700R4 transmission is made from cast aluminium, which adds to its sturdiness and ruggedness. It’s 23.4 inches long, weighs 155 pounds, and has 16 bolts. The tail shaft housing is connected to the main case by four bolts, and the bolt spacing is comparable to that of the THM350 transmission.

Posted In Q&A