How do you adjust the valve on a Honda Foreman 500?
Use the blade screwdriver to pull out the 2 plastic rivets (circled in red), and then pull the cover off the tab (in blue). The next step is to pull off the gas tank shrouds. Pull out the plastic rivets with the blade screwdriver again, there should be 4 on the right side and 5 on the left.
Is the ECU on a Honda Rubicon in fail safe?
Motorcycle Mechanic: Eric, Technician replied 11 years ago the atv’s ecu is in fail safe mode. you will want to pull up stored codes to find out what is faulting the ecu to fail-safe. to do this, key off
Who is the service manager for Honda Rubicon?
Category: Motorcycle Satisfied Customers:1,584 Experience: MMI grad. 7 years experience in Honda, Suzuki, Yamaha, as service manager and tech. Verified Eric and 87 other Motorcycle Specialists are ready to help you
Where are the rivets on a Honda Foreman 500?
The next step is to pull off the gas tank shrouds. Pull out the plastic rivets with the blade screwdriver again, there should be 4 on the right side and 5 on the left. Leave the two rivets on the back of the gas tank shroud in place, it will be easier to remove and reinstall the fenders.
Use the blade screwdriver to pull out the 2 plastic rivets (circled in red), and then pull the cover off the tab (in blue). The next step is to pull off the gas tank shrouds. Pull out the plastic rivets with the blade screwdriver again, there should be 4 on the right side and 5 on the left.
The next step is to pull off the gas tank shrouds. Pull out the plastic rivets with the blade screwdriver again, there should be 4 on the right side and 5 on the left. Leave the two rivets on the back of the gas tank shroud in place, it will be easier to remove and reinstall the fenders.
How to tighten the clutch on a foreman 450?
Thanks for the help guys! loosen the clutch outter nut..with a screw driver..turn the center screw counter clockwise until you feal it start to get tight ?..while holding the outter nut with a wrench ?..turn the center screw back clock-wise 1/4 turn..hold it there with the screw driver…then tighten down the outter nut..this is the pre-settings.