How to change front brakes on a Honda rancher TRX350?
Watch the video above and follow the steps below to change the front brake shoes on a Honda Rancher TRX350 ATV. Step 1. Remove the front wheel Step 2. Use pliers to remove the cotter pin in the center of the hub. Step 3. Use a 27mm socket to remove the axle nut in the center. Step 4. Remove the plug on the drum.
How do you adjust the brakes on a Honda ATV?
To adjust the front brakes, find and remove the red rubber plug in the front drum. You can remove the plug without removing the wheel. Jack the front of the ATV up off the ground. After removing the plug from the adjustment hole, turn the wheel so the hole is straight down near the ground.
Are there front brakes that adjust the same way as back brakes?
Yes, the front brakes adjust in the same way, but the position of the adjusters on the Rancher will be in a different place. If I remember correctly, the adjusters will be in about the 10 o’clock and 4 o’clock positions. As for the back brakes, sounds like your shoes need replacing, if they won’t adjust up enough.
How do you adjust the brake cable on a bike?
Tightening Your Brake Cables Test the tightness of your cables by pulling each brake lever. Loosen the barrel adjusters for minor brake cable adjustments. Unscrew the bolt holding the brake cable on the caliper. Pull the brake cable outward to tighten it. Tighten the bolt holding the brake cable on the caliper.
To adjust the front brakes, find and remove the red rubber plug in the front drum. You can remove the plug without removing the wheel. Jack the front of the ATV up off the ground. After removing the plug from the adjustment hole, turn the wheel so the hole is straight down near the ground.
Yes, the front brakes adjust in the same way, but the position of the adjusters on the Rancher will be in a different place. If I remember correctly, the adjusters will be in about the 10 o’clock and 4 o’clock positions. As for the back brakes, sounds like your shoes need replacing, if they won’t adjust up enough.
Why are my brakes turning backwards on my Honda ATV?
If no one has had the adjusters out and put them back wrong, then the star wheels need to be turned in the upward direction to adjust the brake shoes out. Sometimes, people take them out and put them back in wrong when cleaning them and that makes them turn backwards, but since yours is an ’09, it probably hasn’t been taken apart before.
Where are the star adjusters on a Honda ATV?
Jack the front of the ATV up off the ground. After removing the plug from the adjustment hole, turn the wheel so the hole is straight down near the ground. Using a light, look through the hole and find the “star wheel adjusters”. There will be two of them, one at about the 7 o’clock position and the other at about the 5 o’clock position.