What kind of wire does an AutoMeter use?
Consult a diagram for your computer to verify. Blue: Oil PSI sender wire. Connect this to the Auto Meter oil pressure sender. White: Tachometer signal wire. Where you connect this will depend on what ignition system you have.
How do you install an Auto Meter Gauge?
Using 18 gage wire, route one length through firewall. If a new hole is drilled in the firewall a grommet is recommended. Attach one end to the negative GND (-) spade terminal on . back of gauge, and the opposite end to a good engine ground. See illustration at right. 2. Attach one length of wire to the positive . I
Where does the PSI sender wire go on an AutoMeter?
Blue: Oil PSI sender wire. Connect this to the Auto Meter oil pressure sender. White: Tachometer signal wire. Where you connect this will depend on what ignition system you have. If your engine is distributor equipped, with no ignition box, you may then connect to the negative side of the ignition coil.
How to install an electric speedometer in a car?
1. 8Mount speedometer in a 33/ ” dia. hole. Be careful not to cut the hole too large. 2. 8Cut a 3/ ” dia. hole in the firewall for the speedometer wires. Place a rubber grommet in the hole and route the wires through the grommet to the engine compartment. 3. Connect the speedometer wires as shown in the wiring sections. 4.
What kind of wire do you use on an AutoMeter?
Calibrate your Autometer tachometer to your engine size as follows. If you have a four cylinder engine, clip the two looped wires on the back of the tachometer with wire cutters. For a six cylinder engine, clip just the brown wire, and for an eight cylinder engine do not clip either of the wires.
Where does the factory wire go on a tachometer?
Wire the Tach Adapter’s RED / GREEN wire to the DOWNSTREAM side of the cut Red/Light Green factory wire. The downstream side is the side leading to the engine. The adapter’s black wire goes to a ground point, and the GRAY wire to your tachometer The adapter can be mounted to the fender liner, or wherever else desired.
Blue: Oil PSI sender wire. Connect this to the Auto Meter oil pressure sender. White: Tachometer signal wire. Where you connect this will depend on what ignition system you have. If your engine is distributor equipped, with no ignition box, you may then connect to the negative side of the ignition coil.
How do you wire an Auto meter fuel gauge?
Installing an Auto Meter fuel gauge is an easy task once you have decided how and where to mount it. You can even use your stock fuel-level sender cable, so you will only need to connect four wires for your new gauge to begin working. Select an appropriate mounting location for your new gauge.