What is SC03 abend?
Problem summary An SC03 * * ABEND is issued at program termination * * when a COBOL program OPENs an indexed * * VSAM file with alternate indexes in * * I-O mode and the OPEN was unsuccessful * * (user filestatus is greater than 10 * * and not 97).
How can we resolve U4038 abend in JCL?
PROCEDURE DIVISION. DISPLAY “STARTING PROGRAM..” PERFORM INITIALIZATION PERFORM TERMINATION GOBACK. INITIALIZATION. DISPLAY “OPENING FILE..” OPEN INPUT INFILE IF WS-FILE-STATUS IS NOT EQUAL TO ’00’ THEN GO TO ERROR-EXIT END-IF.
How do you resolve U4038 abend in mainframe?
4038 is a generic abend code which encompasses many ‘user’ abends. I remember specifying a small region parameter resulting in ABEND U4038. The cure was to increase the region card on the job.
What is SB37 sd37 SE37?
SB37: There are not enough space or no more extents available on the current volume. The system gave all the primary space and as much secondary space as it could. Disk volume out of space, cannot write output. SE37: When there are no more volumes available.
What is Msgclass JCL?
So, MSGCLASS is used to specify the format of the output. This means that MSGCLASS defines the output device to which the system messages and JCL related messages are written and printed.
What logs are printed in Sysprint in JCL?
The SYSPRINT DD statement defines the output data set containing the end-of-step reports and any error messages. Normally it defines a SYSOUT data set. If the SYSPRINT DD statement is not in the JCL, the output of SYSPRINT is dynamically allocated to the default SYSOUT class—normally MSGCLASS.
What is the difference between SB37 SD37 and SE37?
Disk volume out of space, cannot write output. SD37: Primary disk space was exceeded and either no secondary space allocation was specified, or it was insufficient. SE37: When there are no more volumes available.
When do you get a S0C Abend from JCL?
S0C Abends are the abnormal ending of Job & when it happens a message from the JCL or Fault Analyzer will indicate that you have a condition code (or return code) such as – S0C1, S0C4, S0C7, etc. We will go through four major S0C abends in this article.
What is the format of a S0C Abend?
System abends follow the format of S nnn, where nnn is a hexadecimal abend code. S0C Abends are the abnormal ending of Job & when it happens a message from the JCL or Fault Analyzer will indicate that you have a condition code (or return code) such as – S0C1, S0C4, S0C7, etc. We will go through four major S0C abends in this article.
Is the Abend a c03 or a 0c3?
You have realized that the abend is a C03 not an 0c3. . . What happens when you use the REGION as suggested (the same i suspect)? Oops! You’re right! Try Googling “C03 ABEND”. You’ll get many hits…. I tried but no success. It is the same error message in the spool. A SC03 indicates that a data set is open and cannot be closed, not so?
What is the format of a user Abend?
User abends format is U nnnn, where nnnn is a decimal user abend code. System abends follow the format of S nnn, where nnn is a hexadecimal abend code. S0C Abends are the abnormal ending of Job & when it happens a message from the JCL or Fault Analyzer will indicate that you have a condition code (or return code) such as – S0C1, S0C4, S0C7, etc.