How do I reset my SonicWall TZ 215?
Load factory default configuration on the Sonicwall TZ 215
- Power off the Sonicwall TZ 215.
- Using a pin hold down the reset button and power the Sonicwall TZ 215 on.
- Release the reset button once the wrench light begins to blink on the front of the Sonicwall TZ 215.
What is SonicWall default password?
admin
SonicWall Default IP Address: 192.168. 1.254. Administration Credentials: admin | password.
How do I reset my SonicWall TZ?
Open a Web browser on your computer, type “192.168. 168.168” into the URL box and press “Enter.” On the SafeMode Management display, click the boot icon on the “Current Firmware with Factory Default Settings” line. This will reboot the SonicWALL to its factory settings state and you can now reconfigure as needed.
How do I reset my SonicWall NSa?
Use a narrow, straight object, like a straightened paper clip or a toothpick, to press and hold the reset button on the back of the security appliance for five to ten seconds. The reset button is in a small hole next to the console port or next to the power supply, depending on your SonicWALL security appliance model.
How do I reset my SonicWALL TZ?
How do I reset my SonicWALL NSa?
How do I factory reset my SonicWALL?
How do I reset my SonicWALL NSA?
How to factory reset a SonicWall TZ..-byte solutions?
Hold down the reset button for 10 seconds. The button is located next to the power jack. The device will reboot when you release the reset button. Set your computers IP address to 192.168.168.167 MASK 255.255.255.0. Connect your computer to the LAN port on the SonicWALL TZ. After the device reboots it will be in recovery mode.
Where is the reset button on a SonicWall?
On an NSa the reset button is located on the front. Once the test light on the device becomes solid or begins to blink then the SonicWall is in safe mode. The device will reboot when you release the reset button. Set your computers IP address to 192.168.168.167 MASK 255.255.255.0.
What should I do if my SonicWall is not connecting?
If you’re having difficulty connecting to your SonicWall device, a SafeMode reset will allow you to change everything on the router back to its default values. Once the reset is complete, you can use the default admin information provided in the user manual to log into the device and get your network set up again.
Where is the factory settings on SonicWall TZ-Weebly?
The SafeMode management display will appear. Click the boot icon for “Current Firmware with Factory Default Settings”. The SonicWall will reboot back to its original factory settings. You can then access via its default IP address of 192.168.168.168 and begin configuration.