What are the codes for the airbags on a car?
Codes 32 to 35 inform drivers of certain issues with the airbags on the driver and passenger sides. Codes 41 to 45 address problems with the RH and LF primary crash sensor. Becoming familiar with each of the 53 airbag codes is essential to vehicle safety.
What does code 12 mean on an airbag?
Code 12 (single flash, pause, two flashes) means that there is a lost battery feed. Code 13 (single flash, pause, three flashes) means that the airbag circuit has shorted to ground and Code 14 (single flash, pause, four flashes) means that the primary crash sensor circuit has shorted to ground.
How to read and clear Isuzu airbag codes?
Isuzu airbag codes can only be read and system cleared with an airbag specific scan tool such as Maxdiag, Autel, OTC, Launch. Beginning in 2007, new SDM installations require configuration by manufacturer download. Jeep airbag codes can only be read and system cleared with an airbag specific scan tool such as Maxdiag, Autel, OTC.
How can I read the airbag code on my Subaru?
Subaru airbag codes can only be read and system cleared with an Asian Airbag specific scanner. The only non-dealer scan tool that works is the Launch Toyota uses flash codes. Airbag codes can be read by using a jumper wire and counting the flashes on the dash light. The system can be cleared with a jumper wire or scanner.
What is air bag code 33?
Sounds like there is an issue with the driver seat pretensioner. (code 33 is driver side pretensioner, code 44 is passenger). If the car you got the seat from had the airbag go off, the pretensioners are junk now. You’ll need to swap the buckle from your old seat to your new seat.
What does airbag code 34 mean?
Code 34 is a circuit fault code for the passenger front pretensioner. The pretensioner is integrated into the buckle assembly. The fault can be caused by the pretensioner itself (most common), a wiring concern or fault in the restraint module.
What does Ford airbag code 27 mean?
Code 27 is a problem passenger airbag disconnect switch. Usual caused by the bulb next to the passenger airbag on/off key being burned out.
What does service air bag message mean?
The service air bag message is the indicator that the system has detected a fault in the air bag system and is there to inform you that you need to get that issue repaired to restore the air bag system to proper operating condition. There is no way to tell without getting the airbag system scanned to know what that issue it.